It's not that hard to disassemble, but to put it back in... Hardest part is the spring. You have to twist it a good couple of times, so that it fits way down into plastic cover, while holding it's outer hooked end in a cut out in the cover. I did it by holding it in a vise with little nut pressing spring's hooked end and then twisted the spring with small pliers, while trying to push it down with a screwdriver. Then, you have to twist it even more with using that can carrier - you put inner hooked end of a spring in its cut out and then turn it counter-clockwise a good half turn, untill you put its protruding "leg: after a matching protruding "stopper" in a cover. Only then you mount everything in reverse. Took me half a day, good luck xD.
I used a big slot screwdriver to put the spring back into place (just small turn an pushing it inside). After hours of trying this worked for me fine in a few seconds. no guarantee that you will break something.
Привіт, у мене такий самий перемикач, перестав крутитися, я розібрав його там все було занедбано , а ось зібрати назад проблематично . Що саме ти мав на увазі в кінці відео махаючи пальцем, чого саме слід не робити? незрозумів.
It's not that hard to disassemble, but to put it back in... Hardest part is the spring. You have to twist it a good couple of times, so that it fits way down into plastic cover, while holding it's outer hooked end in a cut out in the cover. I did it by holding it in a vise with little nut pressing spring's hooked end and then twisted the spring with small pliers, while trying to push it down with a screwdriver. Then, you have to twist it even more with using that can carrier - you put inner hooked end of a spring in its cut out and then turn it counter-clockwise a good half turn, untill you put its protruding "leg: after a matching protruding "stopper" in a cover. Only then you mount everything in reverse. Took me half a day, good luck xD.
would like to see a video about that, because I have to put it back together and can't find a video about that.
I used a big slot screwdriver to put the spring back into place (just small turn an pushing it inside). After hours of trying this worked for me fine in a few seconds. no guarantee that you will break something.
Класне вiдео-менi допомогло! 👍
Привіт, у мене такий самий перемикач, перестав крутитися, я розібрав його там все було занедбано , а ось зібрати назад проблематично . Що саме ти мав на увазі в кінці відео махаючи пальцем, чого саме слід не робити? незрозумів.
make a video showing how to reassemble it and mount it back onto the wheel!!