Maytag Dishwasher Repair - How to replace the Detergent and Rinse Aid Dispenser

Need help replacing the Detergent and Rinse Aid Dispenser (Part #99003317) in your Maytag Dishwasher? Watch this how to video with simple, step-by-step instructions for a successful DIY repair.
Stay safe during your repair! Be sure to check www.fix.com/sa... for proper safety procedures before you begin. Use of this video is at your own risk, without liability to Fix.com.
Fix Part Number: FIX2100601
OEM Part Number: 99003317
Why you might need to replace the Detergent and Rinse Aid Dispenser:
1. Door latch failed
2. Leaking water
3. Not cleaning properly
4. Will not dispense detergent or Jet Dry
What tools you need for this repair:
• ¼ inch nut driver
• Small flat blade screw driver
• #20 Torx screw driver
The information in this video is specific to Maytag, Jenn-Air, Amana, Admiral, Magic Chef and Crosley. To find a Detergent and Rinse Aid Dispenser specific to your model, visit www.fix.com
Not what you’re looking for? For more dishwasher repair help click here: www.fix.com/par...
Where you can buy this part:
www.fix.com/pa...
Connect With Us!
/ fixdotcom
/ fixdotcom
plus.google.co...
/ fix.com
Visit our blog: www.fix.com/blog/
Don’t forget to comment below and subscribe to our channel!

[@conradfisher2563]

Thank you for making that job less intimidating!

[@samanthind8388]

From where I can buy the kit

[@i3diamonds]

I have a Maytag , the pre wash pod dissolves fine, it's the 2 nd pod that does not, should I replace the entire detergent cup? May Tag MDBD880AWB

[@FixDotCom]

Randy, if your dishwasher is not dispensing detergent, the spring and hinge pin on the dispenser door could be the problem. The dispenser door is spring loaded, and is held in the closed position by a catch. Check that the spring
and pin are not bent or broken and replace if required. If the catch is not releasing the door, then you should inspect the timer, the bi-metal release or the wax motor.

[@spiderstone]

Model # MDB401OAW....Maytag Rick

[@spiderstone]

Mr. Fix
Back again.....I was doing routine maintenance....I did cleaning vinegar and all...rags etc....I did push up and down on float .....and cleaned out what looked like plastic sleeve drain ....that's all....
I checked dishwasher later and there was about 3 inches of water in bottom and when I turn it on just timer works.....there is a hum as I type....but no more water comes in ....need help...!
Thanks again Rick....

[@dmf4ehs]

Nicely done! Great explanation of the process