SPLIT AC INSTALLATION...... ||FLIER OUTSIDE THE ROOM || Jabirwaqas.com
Вставка
- Опубліковано 10 вер 2024
- A mini-split system has two main components: an indoor evaporator, which cools the air, and an outdoor condenser, which dissipates heat.
They’re connected by a line set, tubing that passes through a baseball-size hole in the wall, carrying hot refrigerant outside and cold refrigerant in.
Our line set also included cable to power the evaporator and a drain line to carry condensation outside.
Mount the evaporator inside the room on an exterior wall away from direct sunlight, doorways and sources of dust.
Make sure this area of the wall is free of wires, pipes and ducts that would interfere with making a hole for the line set.
Mark the stud locations and fasten the bracket to them with screws.
The line set hole must slope slightly downward to the outside so condensate from the evaporator can drain outside.
Begin by drilling a pilot hole from inside to outside.
Then go outside and make sure no trim or other obstructions will complicate drilling the full-size hole.
Cut with a hole saw from inside, move aside any insulation and inspect the wall cavity for obstructions.
Finish the hole by drilling from the outside.
Carefully uncoil the line set from the back of the evaporator.
With an assistant outside, feed the line set through the hole.
As it emerges, the assistant should gently bend the line set downward and to the side as needed to reach the condenser.
Keep the rigid plastic collar surrounding the line set at the end that connects to the condenser.
The drain line is shorter and goes through last, below the other lines.
Add the drain extension and wrap the joint with electrical tape to keep it secure.
Wrap the foam sleeve around the section of line set within the hole and replace any insulation in the wall cavity that was disturbed.
Then hang the evaporator on the mounting bracket.
Pro tip: Your helper may need to feed a few more inches of the line set outside as you do this.
On the outside, insert the two-piece plastic trim into the hole to prevent any rough edges from damaging the line set.
Set the condenser on a pad on the ground or mount it on a wall bracket so that the refrigerant lines can reach it easily.
Route the line set so it stays tight to the building exterior and doesn’t leapfrog any obstructions. This makes it easier to install a cover.
Ensure the condenser has the recommended clearance from walls and bushes.
Avoid placement where ice or packed snow could fall on it or where other appliances vent.
A location on the east or north side of the structure maximizes cooling efficiency.\
This step varies by manufacturer.
With this system, a locking lever presses the line connections together.
Before powering up, inspect the refrigerant lines for kinks and verify the electrical connections.
Then go inside and set the temperature using the handheld controller.
Insulate and seal the hole in the outside wall, then cover the line set using sections of plastic or metal channel cut to length.
Place the back half of the channel behind the line set, plumb it and anchor it to the wall with self-tapping screws.
Our line set travels horizontally to the compressor, so when we added the channel corner, we drilled a hole in it to allow the drain line to exit straight down. Jabirwaqas.com
بہت اچھی وڈیو ہے
Masha Allah bahot aasan tarika bataya hai aapne साथ ही आसान भाषा भी प्रयोग किया है।
Taisib khan Thankyou
I am impress sir aap nai bahut acchai bataya koi bhi Naya Banda aasani sai seakh jayga thank you sir
Sir aapka tarika bahut khub surat hai thanks
Aasllamualikum sir bhut achaa laga ye video dekh kar mashallah bhaut achaa kam hai me bhi yahi kam kar raha hu sir ye video dekh kar kuch sikh ne ko mila ❤
Aman bht bht shukrya....
Sir aapne bahot hi sahi samjaya hai very good
bohot avhi malumaat wali video hai sir. jo knowledge hai isme... no one has ever told me before
Thankyou Ananth.
Sir aap ne masha allah bhot hi Khoobsurati ke saat samjhaya hai ke jise bilkul bhi nahi maalom ho 👌 wo bhi bhut aasani se unit fitting kar lega
Maza aa gya sir mein aap ka fan ho gya sir allha aap ko hamesh khoosh Rakkhe
Boht nice sir g
Good
Jaza kallah
ماشاءاللّٰہ سر آپ نے بہت بہترین انداز سے سمجھایا
Goog sir
GaJab idea Sir G
Namaskar sir.. Bahut hi achchhe tarike se batate hai aap...
Wah sir kya aasan tarika bataya h fan ho gaya m appka
Good sir
Shandar jabardast
bahot shukriya ankal ji
Knowledge full video
Thank you minhaj
Main aapke sare vdo dekhta hu
Veri good sir
Walaikumusalaam, Very informative video, JAZAKALLAH KHAIR. SIR MAY ALLAH BLESS YOU!
बहुत अछे तरिके से समझाते हो सर आप
Best sir
Bhai sab you're good.
Too much experience.
Md ali Thankyou.
Sir aapne bahut point wali tips batai hai thanku sir
Mashallah
Bahut accha samjhaya sir aapne 🙏
Very good sir
Thankyou Lodhi.
Hlo bro i saw first time ur video is very profitable and knowledgeable thnx bro make a lots of video on basis of our problems
Very helpful full vedio sir thank you so much
Super video sir
Brilliant sir g
Masha Allah kya khub
MA SHA ALLAH good explanation
Your are Great sir im big fan of yours
Many many thanks💓💓
Thank you so much sir
Mashaallah great sir
Thank you
thanks sir really a good knowledge
Great 👌 sir
Sir Very nice Installation
Super Lai bhari sir.........👌👌👌👌
Thanks
Thank you sir I God bless you sir aap bahut achcha samjate hai sir ek electrical & micenical repairing video banado please
sir ap admee bohut assa he
bht bht bht shukrya, sarder
Very nice guru ji ❤❤❤
Very good sir thank you
Mashallah sar Apne bahut acchi formation Di hai aur sar aapane last mein drut gas khol de 5 Nahin kaarvayi hawa bahir Nahin nikaali Jo pipe ke andar the
G. Theek kha aap nay, jb ya video bnae the to us time video bnanay k itna experience nhe Tha... Ar bhi kafi batan btana rh gaeen then... Inshaallah jld dbara AK installation p complete video bna Doon ga... ❣️
New building per piping karke sara ac chethka upper jo lakathahe uska vedio pathaye
Very useful video he sir
ماشاءاللہ بہت خوب
لیکن سر میر ے خیال سے پلیٹ لگانے سے پہلے سوراخ کر لیں تو جو سوراخ کی جگہ کچھ خراب ہوتی ہے تو بعد میں پلیٹ لگانے سے وہ کور ہو جاتی ہے ارو خوبصورتی بھی رہتی ہے
Super
Thanks for support 🖤
Walekumassalam sir apke samjhane ka tarika bahot accha hai or knowledge me bahot ijafa hota h .sir hole saw ka size kya h
Syed, 65mm ha,,, in hole saw man different size bhi mil jatay han...
Vaccum necessary sir... but good installation
Karan.. Thank you..
Good 👍 point
Main jald se jald Ac ka sara kam sikhna chata hu sir
Flare nuts✔
Ac remote k functions k baray mn b video bnayen.
Supar
👍best
Sir, bina vaccum kiye aapne valve khol diya jo mujhe sahi nahi laga
You are very jeans sir .i like your experience.but sir little mistake now
Your not vacuum this ac
Bhai
You given good information thankque
Sahab air nahi nikaala aapne indoor se. Very big mistake
Sir R 410 or R32 inverter ac me charge karne ka full detail me video bnaye as soon as possible.
fupinder singh brother bht jldi bnaon ga,
@@Jabirwaqas kab
Sir installation ke jankari bohat achhi lagi but app ne system ko vacuum Karne ka bataya nahi
Sukhchain singh. Thankyou. Ya video jb bnae the to nya nya channel bnaya tha. Bht kch shi trha nhe smjhaya. Jld ak ar achi c video bnaon ga complete installation p.
Super guruji ❤
Sir aap acchha guide karte he
Thankyou. Mohsin.
Thanks sir ❤g
Amazing
Assalamu Alaikum
Sar Bina vacuum kay Indore ka refrigerant open Karenge
thank you brother 😍😍😍
Sir 3 core and 4 core connection bataye
Hai sir
one small dought indoor brakets bace harizental line equal
I doing indoor uint stand slope leval 2 to 3 mm slope fixing indoor stand right or wrong tell me sir pls
haji sahab vacume nahi kra aap ne.. na pipe ki air nikali neechay walay wall se..
Freon open to ki magar pipes ki air kidhar jai ge?
Zara ye bhi bata dain.?
Shukria.
Amin afzal,,, video sikhanay k lya bnata Hon.. Aksr bht kch btana bhool jata Hon.. Mazrat qabool kejeay... Shukrya...
Sir With out vaccum proses allen key open kr diya apne ye apne janbuj kr kiya ya by mistake
Great 👌🙏
Bhutacha
Lakin Aap indoor plate ki measurment kese le vo aap siling se aur land se kitna measurment lena vo wali video jarur banaoo ..
Mohsin. Zarur bnaon ga. Thankyou.
Jo aapane sakshar pipe aur discharge pipe ko connect Kiya Hua Hai usmein se to aapane pipe ko vacuum nahin kiya to kya vah Chauk Nahin hoga
Sir HVAC system me preventive maintenance ky ky sb check Krna hota haii pls batea
Ali . Preventive maintenance hr company apnay idea say ak procedure bnaty ha..... normally kch maintenance daily hoty ha, kch weekly,, kch monthly,, kch yearly.....agr ali ap specific ksi unit ki poochna chahtay han to btaen,,,
Aapka level meter kitne inch ka hai please reply kare or bataye ki aap hole saw kitne mm ab ka use karte hai. thank u .
Dharam, 65mm ha.
Uncle installation kiye ho acha but vaccum use nahin kiye
Masah Allah sab kuch aapne bhut ache se samjaya hai par sir aapne pipe me jo air pochi hai use bhar nhi nikala hai usse ac ki cooling par farak padhega ....👍
Waseem theek kha ha ap nay... Video bnsnay man itna experience nhe tha, islya bht cheezan btana bhool gya tha.... Next time inshaallah.
Vecum nhi kiya aap ne pipe me jo air hai uske liye vecum jaruri hai
Aapne last mein pipe connection kiya.. par aapne bina vacuum ke lankey open kar di..
Vijay,,, jb ya video bnae the to m youtube p nya tha ,,, to sb cheezon ko achi trha manage nhe kya,,, ar b bht kch missing ha,,,, jldi ak proper video dbara bnaon ga...
Jabreen Bhai apne muje ensaan bna diya😢😢
❣️❣️❣️❣️❣️❣️❣️❣️❣️❣️❣️❣️❣️
Sir vacuum nhi karna kya pipe me hawa reh gyi hogi vacuum kr ke gas kholte te acha tha
Jarmanijit,, she kha ap nay, video skhanay k lya bnae the, to kch cheezan bhol gya....
Sir ji indoor ka jo air hay o vecum nahi kya kiu??
Sir apne end me galti ki he gas perch nahi ki system se
Umer, theek identify kya ha ap nay...
Sir aapne pipe ki air ko nahi nikala
Ranbir singh,, sirf air nhe nkali ar b bht kch bhool gya hon video man...... jb ya video bnae the to youtube p m nya tha,, itna experience nhe tha, bht batoon ko mix up kr jata tha, lakin ab ahsta ahsta experience ho gya ha...... installation p ar universal crd p jldi ak nae video bnaon ga,, jo short b ho ar complete bhi,,
Assalam o alaikum sir good installation
Mjhay pta ha ya video itny achi nhe bny. Soon i ll make better one.
Pipe lamba honay sey kya ac ki cooling Kam ho jati hai??
Help fully video install ac
Sir pipe me joint lagne se koi dikhat to nahi atti pls reply
Rahul,,, piping krtay hway, underground piping man joint na lgaen to bhtr ha,,,agr koi bhi possibility na hi tb to joint krna he hota ha....
Never release gas before proper vacuuming.