Got alot out of this video, was a bit confuse about different housings and interchanging. Thank you
Great video! I have a Maker and for about 2 years I've only used it for Vinyl and on a few rare occasions, cardstock. I finally decided to use my Knife Blade to cut craft foam and it did it perfectly!
However, after switching back to fine point, my cricut has gone into -45 and 99 error mode 😢 and unfortunately im yet to figure out what went wrong. I have done all the troubleshooting recommended by cricut, but none works. I want to upgrade to a Maker 3 or Xtool M1 but im scared the same thing will happen again with changing blades in the cricut.
Great info!! Thanks MGL ❤
Thanks for the information. I saw another video, I can't remember, but they suggested having a small ball of foil. Then you poke your fine point blade to help it clean. What do you think about this tip?
Thank you so much but, what about the joy xtra? Thanks
Thank you! Have a question: how do you get the plastic tips off of blades? I have a couple that came with a plastic cover that I cannot remove. Thanks!
Boogers. I wanted to cut fabrics. Just got an Explorer last week. I should have gotten a Maker☹️
I have cut on my Explore many times with a fine blade and the light grip mat. You do have to bond your fabric to a liner but it can be done.
is there an angle you have to position the blade when you insert it back in the machine? i have read this in the official cricut website
This is great information. I’ve had my Maker 3 for a few years but was not aware of all the blade uses. Thank you so much.