Dometic 9200 Power Awning Motor Removal

This is a short video on the basic steps in the removal of the Dometic model 9200 power awning drive motor. It depicts the parts and steps required and close up views for the DIY . Gives insight on what is involved and what is to be expected before attempting to replace the motor.The gear box removal is not included but shown as well.

[@netgrim]

Thanks. It helped me a lot with my replacement today. I replaced the whole thing. The hard part was to replace the cap and rivets, but it fixed my problem. There is no spring in the roll.

[@RunnRhode]

Thanks very much for posting this so many people are having issues with this awning.

[@acluelesscamper6584]

Thank you for the video. It was instrumental during my replacement today. I agree with you that I don't think this motor has enough power. After installation, it retracted quite slow.

[@cliffdykes1171]

Great video I , have to replace my motor it works usually, but is so slow. Sometimes it won’t retract until I get it started out manually.

[@anthonystewart2992]

Hi is the remote control receiver wired inside the van or is it located in the awning cassette/casing?

[@SilverbackMcGee]

Very useful video. Where did you get the replacement motor? Do you have a link and/or part number? Thanks!

[@joeparedes8998]

Would you be able to just replace the gears to beef them up if there stripped out

[@markwarbeck2968]

My 9200 just started acting up. Did you replace the motor? Where did you find one?

[@bucyruserie4427]

You didn’t drill out the rivets to keep the motor sealed. With dismantling the motor does it tend to let in moisture?