By the time you get that TUNED, she should be in the mid-70's. What are you using for ELECTRONICS & MOTOR ?
Very cool brother. 🤘🤘🤘 need to get out and do come maidens maself
Thank you. So you did some new builds this winter? It's still early weather wise...
Sam Hallstrom yes. I’ve built 2 riggers and a couple hydros. Weather is perking up now, so no excuses!!! I’ve done some build overviews of the boats on my channel. Where ya from
Sam Hallstrom ahhhh Nevermind!!! Didn’t realize u were the ul19 hacker in Wisconsin lol. I’m from northern indiana originally. Your rigger looks great
Haha! Yeah, I'm that guy. The fraud. Your ice should be out I suppose. Time to get them wet...
Sam Hallstrom lol the fraud. Don’t think so. I think you’ve done a hell of a job on that ul19 project. Beats scrapping the hull. Trust me, I’ve done my fair share of odd mods
All fine until the fishing line wraps up in the prop 🥴
what are the cables taped to sponson tubes?
Safety cables to keep the sponsons attached to the hull in case I break a carbon fiber boom tube. The hull would sink without the sponsons attached.
Hey sam how wide is the hull there's a lack of 45 and up riggers except gas out there you think a 45 nitro wood fit comfy in there I emailed Mike but don't want to bother him thanks
It's 4-1/4" outside measurement, with 1/8" walls. So it measures 4" on the inside. It measures 3" at the highest point, not counting the canopy...
I am really happy for your success. Too much epoxy, glue, wood sanding and fine measurements were worth it. Now your fine speed tunings come next for those 60mph's. Congrats.
Thank you very much. It was very enjoyable to build. And rewarding to run it for the first time. I have a lot of tuning and learning about a rigger in front of me.
That was a bit sketchy doing the maiden run in that Hot Pond for a couple of reasons. One being I wasn't going in the water to recover it. I also didn't want to run it onto the ice...Cheers!
Nice. What eletronics you using in the RSX380?
Spektrum SR6000T receiver, Savox SA-1231DG rudder servo, Leopard 4092/1390KV motor, ZTW Seal 200 amp ESC running on two 4S Optipower 4000 mAh lipos in series, so it's an 8S setup...
What is the diameter of boat ? Thanks
Length is 38 inches from the sponson tips to the transom. Width to the outside of the sponsons is 24 inches...
Beautiful boat man!