I want to thanks aswell. The rearlight on the left side had in the grey plastic inside (the part which you loosen at 1:08) a second philips screw at the place which on your right side is in the same place where the light is. Without loosen this screw I couldn't loose the plastic like you did at 1:08. Another difference to my Model is that the two screws which are holding the rearlightcovers wasn't philips but torx screws. Nevertheless that are really tiny problems but think that it might help someone when I mention it. Greetings from germany.
Great video helped me change the lightbulb but complicated on fusion. Ended up loosing the little clip that holds the first screw you removed and now the plastic that is holding the parcel shelf is loose. Guess there is nothing i can do.
Thanks buddy, this was invaluable!! couldn’t have done this without this tutorial 👍
Thanks for the video, I’d never have found the winged nut from the description in the manual 😅
Thanks for the video.
The car's manual does not mention the back plastic screw needs to be unscrewed before lamp removal.
Almost broke the tail lamp 😅
Thank you for this video it was very helpful for me much appreciated
I want to thanks aswell. The rearlight on the left side had in the grey plastic inside (the part which you loosen at 1:08) a second philips screw at the place which on your right side is in the same place where the light is. Without loosen this screw I couldn't loose the plastic like you did at 1:08. Another difference to my Model is that the two screws which are holding the rearlightcovers wasn't philips but torx screws. Nevertheless that are really tiny problems but think that it might help someone when I mention it. Greetings from germany.
Great video helped me change the lightbulb but complicated on fusion. Ended up loosing the little clip that holds the first screw you removed and now the plastic that is holding the parcel shelf is loose. Guess there is nothing i can do.
Thank you for this video it was very helpful for me 👍👍
Thanks for that, just needed to be brave to lever that last clip out.
Thank you ,it was very helpful!
Poor fusion and it’s the fusion 3 it was scrapped
Don't use a pry bar. You'll damage the paint on the body and may break the light.
Just grap the light unit with your hands and pull it off.
Hi
Coul you tell.me in this car lights...which one is the positive,which one negative and earth? Thank
Very helpful, thank you very much.
I'm guessing, if you can't drop the seat on the side you need to change, you can't access the back of the lights to remove them to change the bulb??
Gracias 🤚
Thanks, I wasnt sure if there is any trick to that last holder.
thank you
a garage changed mine last year for a second hand unit - now my fusion is full of water! Is there a seal they may have left off?
My wife's has always had water in it. I've reseated the rubber seal but the water still gets in. I'm 5hinking of drilling a drain hole I the bottom
@@philipbrookes6676 Hi, I made a homemade seal around where the wires feed in to the light - seems to have fixed it!
I have drilled a whole at the bottom so now its fine no more moisture inside
WHAT A PALAVA !!!!!!!!!!!!!!!!! POXY MODERN MOTORS 😔😔😔😔😔😔😔😔ARE CRAP g