Advansor CO2 Booster System Tech Tip - Filter-drier Change-out

Поділитися
Вставка
  • Опубліковано 22 сер 2024
  • This tech tip shows the steps required to change a filter drier on a CO2 Booster system.

КОМЕНТАРІ • 5

  • @sil0795
    @sil0795 6 місяців тому

    What I am missing here is that the time that the system is open had to be limited to a minimum because of moisture that is migrating into the system.
    When you take the drier cores out put the cap right back on the housing with a few bolts, then change the drier cores.

  • @danfosscarel7911
    @danfosscarel7911 Рік тому +1

    Достаточно низкая квалификация техника. Шланги не соответствуют выполняемой задаче. Не могу смотреть на то как он крутит рожковым ключом фильтр без перчаток, забыв поменять прокладки на крышке фильтра. Хотелось бы видеть подключение вакуумного насоса после замены картриджа.

  • @john198292
    @john198292 5 років тому +1

    Thanks. The description says booster system, but wouldn't this be a cascade system since it has CO2 liquid pumps? A booster system does not usually have liquid pumps.

    • @keithturner4939
      @keithturner4939 3 роки тому

      Same principle of changing the liquid Dryer 👍❄️

    • @jimmyp5487
      @jimmyp5487 Рік тому

      cascade uses c02 only, no secondary refer like this equipment in this video. looked like this equipment was using c02 liquid for LT with secondary refer... i believe thats right. ive been working on some booster c02 racks recently and just started servicing secondary hfc c02 systems. very interesting and different but i am liking it. knowledge of controls will benefit espcially on booster racks. thanks for the video HP! You guys rock