Hello, 2 beam 230 and light table 512 address is set to 1 and 17, 1 of the robot is 8, after 10 minutes the bulb goes out, the bulb has changed, the fans have changed, I have not been able to figure out the solution for this.
Tengo una beam 230 enciende normal el bombillo pero al rato se apaga el bombillo me voy ala pantalla le doy lámpara on y enciende y al rato se pone lámpara off
Dengo 7r 230 beam que se tiene que prender la lámpara cada ves que se prende. Trabajan bien pero esto apareció después de una renta de los beam que manejaban otro controlador de luces Ya se reseteo el cabezal y el foco pero si igual no sé si sea por programación que le movieron o que
I did not. For some reason the lamp control has to be reset. Make sure when you turn the lamp control from OFF to ON to ONLY do it ONCE. If you previously had already messed with the lamp control,turn the lamp control on and off a couple of times until you see the lamp strike on. I recommend removing the housing covers to see inside easier.
Hey man..its a good thing i removed the housing..and you re right..so that u will see whats wrong with it..i see that the bulb was dislocated in its correct position...maybe its because of the shipping fault ..lol...the moving ok now..thanks man..im gonna buy another one..✌️😎
Hello, 2 beam 230 and light table 512 address is set to 1 and 17, 1 of the robot is 8, after 10 minutes the bulb goes out, the bulb has changed, the fans have changed, I have not been able to figure out the solution for this.
Hi sir my beam 230 is showing change lamp, I have changed lamp and ballast but is not working
I would make sure all of your wires are connected properly.
HY!
My MH7R its moving, lamp is on, but dont change colour and gobo, is only pale white. An advice? Thank you!
Hey my lamp is saying lighterror on the error log everything seems to work except the lamp it won't come on. ?
There is a possibility that the lamp disconnected. You would have to open the fixture up to see inside.
Tengo una beam 230 enciende normal el bombillo pero al rato se apaga el bombillo me voy ala pantalla le doy lámpara on y enciende y al rato se pone lámpara off
Encontraste solución amigo??
Dengo 7r 230 beam que se tiene que prender la lámpara cada ves que se prende.
Trabajan bien pero esto apareció después de una renta de los beam que manejaban otro controlador de luces
Ya se reseteo el cabezal y el foco pero si igual no sé si sea por programación que le movieron o que
Did you change your igniter ballast or power supply?
I did not. For some reason the lamp control has to be reset. Make sure when you turn the lamp control from OFF to ON to ONLY do it ONCE. If you previously had already messed with the lamp control,turn the lamp control on and off a couple of times until you see the lamp strike on. I recommend removing the housing covers to see inside easier.
@@kennylunaaa5596 ok..let me try that
@@aclizarda goodluck man. Hope it works
Hey man..its a good thing i removed the housing..and you re right..so that u will see whats wrong with it..i see that the bulb was dislocated in its correct position...maybe its because of the shipping fault ..lol...the moving ok now..thanks man..im gonna buy another one..✌️😎
@@aclizarda that’s awesome!
Sir dko masundan ang bilis po kc demo new po