Ok took me 4-5x but I finally got it working. The tape you had on the red & blue hose was what made the difference for me, so I did it too. I calculated an inch put the tape on and realised the hoses were not where they should be. The hoses weren't in as far as they should've been, I had water all over the place took it apart 4-5 x and got it. Very proud of myself! Also the collar had some play in it but that wasn't the problem it was the hoses. All good thank you
Thank you very much. I had trouble replacing the filter as it did not fit. I have the same system and they sent me the 10-0186 cartridge with this screw piece on the bottom. My old filter had a rounded bottom. Have you experienced this and why there are two different bottoms for these filters? I received the same filter you installed and mine did not fit. Look forward to any advice or is there a different model number that I should be using for ordering?
@@EmileTheart I have had the same problem before because i ordered the wrong one, i think it is for a system without UV. Thank you for asking they today i was sent the wrong filter and will not bother opening because it is wraped and dont want any problems with return :-{
When I put the white locking ring back on, the unit always leaks, the locking ring doesn't do up tight just turns then stops. Only way to stop it leaking is to stick rubber bits under the locking ring to wedge it more.? Is it missing a rubber seal or something?
I dont recall the white ring having a seal. Mabe check the seal on the cartridge. Also check that the rim is clean. Otherwise you might have to take it to your nearest repair center.
I've had a similar issue once. Check that the top part of the filter is clean and dry. Also check the inside of the black lid. I found a bit of moisture in there and that messed with the link between the filter and electronic unit. Hope this helps.
@@EmileTheart Thanks for your reply, I just tried it, it still not working, it doesn't even gush the black water as it used to be. I think the cartridge may be a damaged one.
Yellow usually is a result of iron in water, White could be lots of calcium. The worst contaminants may be colorless chemicals and chlorine of course has no color in water. If the city ever turn off the water in your area, turning it back on releases all sorts of crud into your pipes.
WRONG ... After you fix the tubes you need to run the water at least 5 minutes, until black colour remove from the water. Then you install the electronic part. wrong instructions..
Thank you brother. Every once a year i will watch your video. Youre a lifesaver 🤣
Ok took me 4-5x but I finally got it working. The tape you had on the red & blue hose was what made the difference for me, so I did it too. I calculated an inch put the tape on and realised the hoses were not where they should be. The hoses weren't in as far as they should've been, I had water all over the place took it apart 4-5 x and got it. Very proud of myself! Also the collar had some play in it but that wasn't the problem it was the hoses. All good thank you
Is their play in the collar? It doesn't secure so tight?
Thank you very much. I had trouble replacing the filter as it did not fit. I have the same system and they sent me the 10-0186 cartridge with this screw piece on the bottom. My old filter had a rounded bottom. Have you experienced this and why there are two different bottoms for these filters? I received the same filter you installed and mine did not fit. Look forward to any advice or is there a different model number that I should be using for ordering?
I have never had that problem. Best would be to contact your local distributor and ask them. Sorry couldn't be of more assistance.
@@EmileTheart I have had the same problem before because i ordered the wrong one, i think it is for a system without UV. Thank you for asking they today i was sent the wrong filter and will not bother opening because it is wraped and dont want any problems with return :-{
Thank you. I gather that when I turn it on and beeps is bc is not installed properly or it needs to be replaced?
It starts beeping to warn you that a filter change is eminent. When the monitoring unit flashes all red it is time to replace.
My problem after change why still have installed cartridge
Replacement why like that?
When I put the white locking ring back on, the unit always leaks, the locking ring doesn't do up tight just turns then stops. Only way to stop it leaking is to stick rubber bits under the locking ring to wedge it more.? Is it missing a rubber seal or something?
I dont recall the white ring having a seal. Mabe check the seal on the cartridge. Also check that the rim is clean. Otherwise you might have to take it to your nearest repair center.
Thank you
great sharing ,Thank you
I replaced the filter, but it keeps telling me that I haven't installed the cartridge, the red light on the top right is on.
I've had a similar issue once. Check that the top part of the filter is clean and dry. Also check the inside of the black lid. I found a bit of moisture in there and that messed with the link between the filter and electronic unit. Hope this helps.
@@EmileTheart Thanks for your reply, I just tried it, it still not working, it doesn't even gush the black water as it used to be. I think the cartridge may be a damaged one.
How do you replace the ultra violet light?
You replace the entire cartridge. The UV tube does not come as a separate part.
@@EmileTheart Thanks. I just bought a house with one of these under the sink. Never seen one before. Will pull it apart tomorrow and check it out.
@@C99631 Where are you based?
@@EmileTheart Shepparton
Where to buy new catridge please?
Contact your local Amway office. They will put you in touch with a distributor.
great sharing, thanks a lot!
Where did you buy your filter?
Hi Warren, please go to my YT profile "About" page . You can send me an email from there.
thank you sir💖
Really useful thanks
thanks a lot
Thank you mt brotha
My old cartridge is absolutely white!
Koshka219 it didn't filter anything
means your tap water is very clean
Yellow usually is a result of iron in water, White could be lots of calcium. The worst contaminants may be colorless chemicals and chlorine of course has no color in water. If the city ever turn off the water in your area, turning it back on releases all sorts of crud into your pipes.
WRONG ... After you fix the tubes you need to run the water at least 5 minutes, until black colour remove from the water. Then you install the electronic part. wrong instructions..
Thank you!🌺