Tutorial MasterCam 2019: Draw Sweep and ToolPath Surface Finish Flowline

[@dbtpvaduthala2688]

sir which option is suitable for roughing.

[@sunnyagro3275]

Ball mill will be break if we proceed that program cause tool plunge about 2 to 3 mm from 0 point

[@adolfolowskibautista646]

You should put subtitles for we the latinos

[@iyappananu3878]

Put udrill flute draw & programs pls

[@technologythetool]

I did not understand your question well

[@iyappananu3878]

@@technologythetool i wanna Udrill profile 3d desing in mastercam sir

[@rachadm745]

Thank you sir , but please i need full circle

[@rachadm745]

Like your drawing but i need circle

[@rachadm745]

Please check this link

[@Universe_lord_rahul]

Program should start from top 0 point

[@technologythetool]

Yes, it is generally

[@Universe_lord_rahul]

@@technologythetool then why it is not working properly?? Because by this method first cut will be too high