Initially, when Current is injected it would take some time to get stable readings. After which the readings shouldn't fluctuate. If the problem still persists you can connect with our after-sales team service@scopetnm.com
Hi, you can check out our DCRM case study on our recent blog post at: scopetnm.blog/2020/04/24/success-story-preventing-circuit-breaker-failure-at-one-of-indias-largest-electric-power-transmission-utilities/
Pls give me the reason y values get fluctuated
Initially, when Current is injected it would take some time to get stable readings. After which the readings shouldn't fluctuate. If the problem still persists you can connect with our after-sales team service@scopetnm.com
@@scopetnm1988 thanku so much sir it’s useful if u can give ur contact number
helpful... keep it up.. we want more
Why give a 100A current any standard
Applying current should not exceed more than 15% of rated current. Somewhere 10A also using.
Please upload SCOPE technical webinars also in your channels.
We would be conducting webinar often, most of them are on this Channel
Simply supper
Very good. Thanks 🙏🙏🙏🙏
In CRM test We Inject Current then Why Voltage ... Leads???
Voltage leads are used to measure the drop across the Device Under Test (DUT). SCOPE CRM uses 4 wire measurement
Current output cables are connected....u didn't tell about the voltage cable...I think have to connect along with current cable
Yes, voltage cable needs to be connected near current cable as shown at 0:41
Can we check HT motor winding resistance ?
@Mrutyunjaya Behera , In Order to check winding Resistance of HT Motor you would have to use our Product TRM 25 or TRM 50
👍
Please publish DCRM Test also.
Hi, you can check out our DCRM case study on our recent blog post at:
scopetnm.blog/2020/04/24/success-story-preventing-circuit-breaker-failure-at-one-of-indias-largest-electric-power-transmission-utilities/