If the fuel lines are still good, just dump out all the old fuel. Then add about an ounce of Mechanic in a Bottle and use the primer bulb to make sure the additive gets into the carb. Leave it sit overnight. Add fresh gas and it should start.
Fantastic instructions! Thank you! Q: what are the SIZES of the tubes? And, is the green tube that exits the tank the SAME size as the clear/yellowish one? (Mine are dried out and broken so it's hard to tell.) I found tubes that are 5 mm OD x 2.5mm ID, but I'm not sure if those are correct.
I don't remember the sizes... but I usually order a variety hose package and then just size them by eye and feel... tight and snug into the tank and on the carb. Here is a link you could look at to get started or Amazon I am sure has them. www.ebay.com/itm/155018542119?mkevt=1&mkpid=0&emsid=e11051.m43.l1123&mkcid=7&ch=osgood&euid=741bd19074fa4a72840da0284e01ba45&bu=44240417862&osub=-1%7E1&crd=20220714013219&segname=11051
I have a 10inch craftsman cultivator 2.0 gas power and the wire to the sparkplug has been cut, instead of spending $70 on a new wire can't I just replace the wire from another small engine???
The wire attaches at one end to the coil (which would have to match your machine) and the other end has the connector to the spark plug with a rubber cap. Have you looked online at an aftermarket coil?... I wouldn't think it would cost that much. Also are you sure the wire has been cut and not just the end cap came off?
@@helpinguonline I think I got ripped because the spark plug is broke halfway. I called a place and they said it would have to be ordered and cost around $70😳😳. I rather just take one from another engine and replace it if I could
You may want to check your coil. When they Are starting to go bad that can happen. While it is hot and when that happens check and see if you have spark.
Good video. Thanks
could you please let me know what is the model for carb kit ?
I have a situation where I don't have a purge bulb, any option to bipass fuel to run engine or a modified version of purge bulb to run motor?
If the fuel lines are still good, just dump out all the old fuel. Then add about an ounce of Mechanic in a Bottle and use the primer bulb to make sure the additive gets into the carb. Leave it sit overnight. Add fresh gas and it should start.
Fantastic instructions! Thank you! Q: what are the SIZES of the tubes? And, is the green tube that exits the tank the SAME size as the clear/yellowish one? (Mine are dried out and broken so it's hard to tell.) I found tubes that are 5 mm OD x 2.5mm ID, but I'm not sure if those are correct.
I don't remember the sizes... but I usually order a variety hose package and then just size them by eye and feel... tight and snug into the tank and on the carb.
Here is a link you could look at to get started or Amazon I am sure has them.
www.ebay.com/itm/155018542119?mkevt=1&mkpid=0&emsid=e11051.m43.l1123&mkcid=7&ch=osgood&euid=741bd19074fa4a72840da0284e01ba45&bu=44240417862&osub=-1%7E1&crd=20220714013219&segname=11051
I have a 10inch craftsman cultivator 2.0 gas power and the wire to the sparkplug has been cut, instead of spending $70 on a new wire can't I just replace the wire from another small engine???
The wire attaches at one end to the coil (which would have to match your machine) and the other end has the connector to the spark plug with a rubber cap. Have you looked online at an aftermarket coil?... I wouldn't think it would cost that much. Also are you sure the wire has been cut and not just the end cap came off?
@@helpinguonline I think I got ripped because the spark plug is broke halfway. I called a place and they said it would have to be ordered and cost around $70😳😳. I rather just take one from another engine and replace it if I could
I have a craftsman with 2p technology that is similar to this tiller. Mine starts but after 5minutes of running it just turns off.
You may want to check your coil. When they Are starting to go bad that can happen. While it is hot and when that happens check and see if you have spark.
Helping U online have to buy new Carburetor kit from Amazon or eBay
Buy carb kit from the Dealer is expensive
soak it in break fuled