Building my 2dof racing simulator.
Вставка
- Опубліковано 14 жов 2024
- I built this race sim back in 2012.
Some info:
AVR Motion Controller
DSMhb (DIY MOSFET H-bridge motor driver)
2DOF firmware v1.0 for PWM AMC v1.5 board (by Thanos / TronicGr)
Running x-sim on the PC.
Wiper motors from vw polo.
Potentiometers. 270*
Racing Wheel : logitech g27.
Handbrake: homemade.
PSU: 12v 30A switched power supply from ebay.
Se my other videos for a demo.
Hallo Martin, which kind of motors are u using? Works very soft, nice work.
Thanks. Regular vw polo wiper motors.
Thank you, how much watt they have?
@@kaygilgenast2562 around 40 watt. When on full load i think they peak at the double. I recommend a motordriver able to handle at least 10 amps for each motor.
high class build, congrats
Thanks mate.
Can you mabey send a list with the products which you user to make the motion system and write the times of the video next to it ?
Hi. The motion controller i use is called "AVR motion controller 1.5" And my H-bridge (putting out power to the motors ) is called "dual_simple_Mosfet_hbridge_1_2b"
A guy named Thanos made the plans to make your own H-bridge and controller. I bought the parts and soldered the PCB's
His youtube channel is called "Thanos 6DOF motion sim electronics".
The software used to controll the motion controller is cattled X-sim, check the forum.
www.x-sim.de
I built my simulator back in 2012 and you should look for some other newer controller.
Tow Mater Oke thank you very much 💪
Tow Mater Can you mabey send a link of the plan ?
Here is a link to the updated plans for the motion controller.
www.x-sim.de/forum/viewtopic.php?f=39&t=132
You could also use a arduino for motion controller:
www.x-sim.de/forum/viewtopic.php?f=39&t=723
All the information you need are to be found in the X-sim forums / webpage.
Good luck.
Tow Mater Thanks man
hello what an amazing job, you know where I can find a complete tutorial for this movement system
Thanks. Check out the x sim.de website. Best regards
@@Martin-bq8hd thanks
Hallo matin, how long is the lever on your motors?
Hello. About 50mm lever. Maximun travel is then 100 mm on each side. More travel would demand bigger motors.
Wow thats 22 degrees roll. Is my thinking correct?
@@kaygilgenast2562 it sure sounds mutch. It all depends how far out from centre you connect the levers i guess, and how the controller uses the travel.