Isuzu Rodeo 6vd1 3.2 v6 Timing Procedure Part 9

[@guyfrancis6883]

Ahhh...So that's the sequence! Mine has been fighting me and I have walked away twice. Even got my son and wife out at one stage.
Good to see you got through the clicking of the cams into position (mine was out) and the belt sequence with the wheel on last (may need to turn the crank to loosen the belt for RH side of belt ... LHS when looking at the car).
Now where was I...
Thanks
GF Wollongong

[@guyfrancis6883]

Finally got it ... but word of warning.
A timing belt kit comes with belt, tensioner and tension wheel (last thing installed here).
Check that the (pivot) bolt will thread in. I have wasted too much time trying to get the bolt to bite ... only to find that it was a different thread and reused the old one.
This is twice I have run into this problem.
So preassemble before final installation ... if new nuts and bolts have to join old stuff.

[@joseroa7619]

muy bueno tu tutorial te felicito gracias sigue asi.... adelante gracias

[@chrisrauhala9745]

Are new belts normally done at 100000km intervals?

[@RONARAMI]

buenas tardes, recientemente realice el cambio de la correa de tiempo, pero solo funciona 3 cilindros, que pudo salir mal?? gracias por su ayuda

[@edgarubaldocamposguzman7154]

una de las camaras te quedo fuera de tiempo...

[@patricio3173]

y para el motor 3.2 pero de 1 solo arbol en cada cabeza

[@mauno380]

You are too selfish. Not showing any