3 пин “IGE” в оригинальной японской схеме имеет подтяжку к 12в, фактически там её нет, возможно в авто это осуществляется в блоке MULTIPLEX. Можно попробовать через сопротивление сделать самому эту подтяжку.
Enjoy your information. Did you ever run into that 3 lines of data on new toyotas that need to convert to 12 digit pin? It's weird as it's not the 96 seed code so can't convert to 12 digit pin. Any suggestions without having to use TIS to get the 96 seed code or a walk-around. Thanks.
Hi, did you manage to open ESL or Reset ESL? I have a 6 pins ESL Toyota smart key, following the instructions IM608 with XP400 PRO, wired everything as in picture, it says Opening succeeded, but steering wheel will not disengage, remain. Tried to reset ESL, but kept saying Resetting failed. Any suggestion will be most welcome. Thanks in advance
I’m going through the same problem now, I just replaced my heater core and dropped the steering column and disconnected all the harnesses from the steering wheel lock,after connecting everything back into place. Now the security light is blinking and it would not start nor the steering wheel is unlocking. Pls help
Hi, most likely you have something disconnected.. the id code box I believe is near heater core, most likely you forgot to plug it back in... that would mean dropping the dash AGAIN... 🤒
always great work and informative..
3 пин “IGE” в оригинальной японской схеме имеет подтяжку к 12в, фактически там её нет, возможно в авто это осуществляется в блоке MULTIPLEX. Можно попробовать через сопротивление сделать самому эту подтяжку.
Enjoy your information. Did you ever run into that 3 lines of data on new toyotas that need to convert to 12 digit pin? It's weird as it's not the 96 seed code so can't convert to 12 digit pin. Any suggestions without having to use TIS to get the 96 seed code or a walk-around. Thanks.
Failure is not an option 💯. As mentioned, I dealt a very similar situation before and can share my notes if you think it would help.
Email me, let's discuss thanks!
Globalcommerceca@gmail.com
Hi, did you manage to open ESL or Reset ESL?
I have a 6 pins ESL Toyota smart key, following the instructions IM608 with XP400 PRO, wired everything as in picture, it says Opening succeeded, but steering wheel will not disengage, remain.
Tried to reset ESL, but kept saying Resetting failed.
Any suggestion will be most welcome.
Thanks in advance
You can change the motor inside the steering lock
I’m going through the same problem now, I just replaced my heater core and dropped the steering column and disconnected all the harnesses from the steering wheel lock,after connecting everything back into place. Now the security light is blinking and it would not start nor the steering wheel is unlocking. Pls help
Hi, most likely you have something disconnected.. the id code box I believe is near heater core, most likely you forgot to plug it back in... that would mean dropping the dash AGAIN... 🤒
@@globalcommerce7654 Thanks for replying back, I'll double check the i d box again.