Thank you, this was very insightful... I understand this isn't for the absolute beginner, it did take me a minute to figure out what you were doing with the lines as far as deselecting by hitting escape, etc. since it wasn't mentioned, but because I've been at it for a little bit, I was able to figure it out. A little note on the screen may make it more obvious to others if this is helpful feedback.
With this exercise being a revolve i always find it easiest to imagen that I am cutting the component in half and looking at just the cross-section. I rough out the shape that I can see in that view and then add dimension after. Hope that helps!!!
Thank you, this was very insightful... I understand this isn't for the absolute beginner, it did take me a minute to figure out what you were doing with the lines as far as deselecting by hitting escape, etc. since it wasn't mentioned, but because I've been at it for a little bit, I was able to figure it out. A little note on the screen may make it more obvious to others if this is helpful feedback.
Great video Dave much better quality in terms of the recording/screen resolution. Keep the videos coming - they are really helpful :)
Do you have any tips that enable me to understand the drawing model ? It’s easy to follow your sketch but hard to know how you sketch it ?
With this exercise being a revolve i always find it easiest to imagen that I am cutting the component in half and looking at just the cross-section. I rough out the shape that I can see in that view and then add dimension after.
Hope that helps!!!
Thank you
neep help on a revolve part please
If u have a drawing send it to guidetosolidworks@gmail.com and I will have a look.
Perfect
10/10
D tier audio