bike died yesterday bc stator failed and battery went dry i got two push starts from passer by's but it completely died after a while i had to leave my bike and hitch hike home. i will try your fix and swap out my stator , love from Australia!
Hi good day please am Abraham from Ghana please I have a Hyosung 250 and some problem is worrying me which my bike is responding and the same time the ECU is heating please what is the problem and my dashboard is blank too
Hi one question after you change everything did you use a new gasket cover or you used the old one ?? If the old one is ok it is necessary to apply rvt silicone?? Thanks
@@henrybottia3937 It's been ages..😄 For me, nothing was wrong there. If reworking, use another gasket, they're cheap. Else use a thin coat of RTV to close it up, if it's 1-component. Don't bother with the other silicone types where you have to mix from 2 tubes, it'll ruin your oil and the engine next. The secret to getting proper voltage across the bike are the wires: the company gave a 3rd class harness which causes all kinds of baloney. Replace the entire run from connector to connector where there's a sag. Any good electrical wire of correct thickness wrapped with a layer of electrical tape will do. Good Luck.
The cooling fan was off, so I don’t know the mechanic here what to do. He turned it on, but the f1 sign was shown and the lamp does not always light up after operation, and the radiator is very hot, as it is always so hot that it has holes for water smuggling and the holder of the bike was working when I download it now it does not work without it I raise the entire stand except for the upper position, so what is this please?
Hi.. I have starting problem with hyosung gt 250r... If I go to start bike doesn't start.. Sometime starts with 1 shot.... And when running for long time , if I stop and try to start again it doesn't start. But engine turning.... I checked fuel pump, injector, battery good, spark plug Can u suggest me wat can be the problem
It shows me f1 on the screen hasong st7. 2013 and there is no mechanic here who understands haysong and I always notice a hole cut in the water radiator and I fix it and it repeats. Now how do I fix the f1 and find out the error please send me the method because there is no mechanic here who understands haysong please
We in India get the job done. How does it make a difference, working off the floor or on a work bench as long as the outcome stays the same or maybe better....Hope you get my point Ron...
@@enginetorque5975 Just wondering I have a hyosung gt 650 and is discharging very quickly out on the road and the lights go dim at night and the clocks all act up and is that the stator that is causing this problem. And when I had the stator off one of the coil segments were black.
I am having probably the same problem as I too got stranded after running few kms yesterday. I am in a fix. Can you please help me with ur contact no. Sir
bike died yesterday bc stator failed and battery went dry i got two push starts from passer by's but it completely died after a while i had to leave my bike and hitch hike home. i will try your fix and swap out my stator , love from Australia!
hi mate, how did everything work ?, where did you get the new stator here in australia ?
@@raimundobailacpereira4988 it was the rectifier I cycled out to a shop to buy one. That was some time ago and the bike has been healthy since. Thanks
Would like more about ur bike.all problems and how u fixed them and where u ordered ur new parts from.??
Thank u for this video
Tq for sharing bro. 🫡
Hi good day please am Abraham from Ghana please I have a Hyosung 250 and some problem is worrying me which my bike is responding and the same time the ECU is heating please what is the problem and my dashboard is blank too
Where I can get hyosung parts
Where is available sir the parts of Hyosung
Hi! How did you know the stator was at fault? What resistance should the wires coming from the stator show?
Hi one question after you change everything did you use a new gasket cover or you used the old one ?? If the old one is ok it is necessary to apply rvt silicone?? Thanks
@@henrybottia3937 It's been ages..😄 For me, nothing was wrong there. If reworking, use another gasket, they're cheap. Else use a thin coat of RTV to close it up, if it's 1-component. Don't bother with the other silicone types where you have to mix from 2 tubes, it'll ruin your oil and the engine next.
The secret to getting proper voltage across the bike are the wires: the company gave a 3rd class harness which causes all kinds of baloney. Replace the entire run from connector to connector where there's a sag. Any good electrical wire of correct thickness wrapped with a layer of electrical tape will do. Good Luck.
The cooling fan was off, so I don’t know the mechanic here what to do. He turned it on, but the f1 sign was shown and the lamp does not always light up after operation, and the radiator is very hot, as it is always so hot that it has holes for water smuggling and the holder of the bike was working when I download it now it does not work without it I raise the entire stand except for the upper position, so what is this please?
Same issue here in my gtr 2013 model just yesterday I leave bike to the garage
Do you still have it?
My Hyosung has been giving me the same problem can you tell me where did you get the new magnetic coil from ,I've been searching for a while
I'm from Shillong I have some problems with my bike
Can this coil be rewinded ?
Bhaiya iska price kitna hai
Very helpful!!!
Thnks bro
Hey bro I noticed that while putting the magnet cover back you didn't put on a new gasket, didn't it gave you leaking problem later?
where I can buy new gaskit My gt has leak problem form the side
@@कार्टूननेट you should check out from "OPen Throttle Racers"
جوزه مال حماوه وين صير
Not really 12.5-13V it is said in the book 13.5-15V.
Hi.. I have starting problem with hyosung gt 250r... If I go to start bike doesn't start.. Sometime starts with 1 shot.... And when running for long time , if I stop and try to start again it doesn't start. But engine turning.... I checked fuel pump, injector, battery good, spark plug
Can u suggest me wat can be the problem
Did u find the problem?
It shows me f1 on the screen hasong st7. 2013 and there is no mechanic here who understands haysong and I always notice a hole cut in the water radiator and I fix it and it repeats. Now how do I fix the f1 and find out the error please send me the method because there is no mechanic here who understands haysong please
I am a mechanic
Can’t even show the repair was successful?
Why do people from India like to work off the Floor? Don’t they have any work benches?
We in India get the job done. How does it make a difference, working off the floor or on a work bench as long as the outcome stays the same or maybe better....Hope you get my point Ron...
@@enginetorque5975
Just wondering I have a hyosung gt 650 and is discharging very quickly out on the road and the lights go dim at night and the clocks all act up and is that the stator that is causing this problem. And when I had the stator off one of the coil segments were black.
I am having probably the same problem as I too got stranded after running few kms yesterday. I am in a fix. Can you please help me with ur contact no. Sir
Could you please share the cost estimates of this job?
Help me
Pickup problem solution