Thank you for taking the time to put these videos together! I was gifted this machine and was feeling a bit overwhelmed until I stumbled upon this video. I look forward to watching more and following along.
I love UGS. I want to change out controller on my Queenant to GRBL and run UGS. I also have a BOBSCNC kl744 and have had zero issues with arduino uno running GRBL and UGS.
Thank you for your video , I managed to do my first cut with carveco. I'm still trying figure out why my machine will not do cut files off a memory card.
Hi, hoping someone may be able to help. Ive followed the video but whenever i try to perform the z probe function It just alarms saying it is hitting the hard stop. Any advice appreciated
@@rogerwebbchannel2cncsandmo997 Thanks very much this solved the issue. Sadly I now have another issue! when trying to run the spindle I get a (ALARM:1) Hard limit has been triggered fault. Could this be a broken spindle? Thanks again
I'm still trying to fig this out. I don't like the mm , I prefer inches. If i setup the UGS program in mm. Will it effect my project files that i did in inches ???
You will need Carvec Maker My CARVECO/ArtCAM 5% discount code is ROGERWEBB5798 (ONLY AT THIS ADDRESS BELOW) store-us.carveco.com/collections/roger-webb-discounted-products store-us.carveco.com/?ref=B40mt_z8N7xiu
Thank you for taking the time to put these videos together! I was gifted this machine and was feeling a bit overwhelmed until I stumbled upon this video. I look forward to watching more and following along.
You're very welcome!
I think your pretty damn awesome man! Thank you !
I love UGS. I want to change out controller on my Queenant to GRBL and run UGS. I also have a BOBSCNC kl744 and have had zero issues with arduino uno running GRBL and UGS.
good job, my UGS lost gcode editor, doesn't show gcode, how to fix?
Do you have a video on the override function?
I cant get mine to work.
Did you use the STM32 breakout board reflashed for GRBL compatibility?
In 4 weeks I'll be trying it out.
Thank you for your video , I managed to do my first cut with carveco. I'm still trying figure out why my machine will not do cut files off a memory card.
Save in G-code mm(tap) or G-code inch (tap)
Hi, hoping someone may be able to help. Ive followed the video but whenever i try to perform the z probe function It just alarms saying it is hitting the hard stop. Any advice appreciated
Change the + and - wires around on the probe
@@rogerwebbchannel2cncsandmo997 Thanks very much this solved the issue. Sadly I now have another issue! when trying to run the spindle I get a (ALARM:1) Hard limit has been triggered fault. Could this be a broken spindle? Thanks again
I'm still trying to fig this out. I don't like the mm , I prefer inches. If i setup the UGS program in mm. Will it effect my project files that i did in inches ???
Set UGS up in inches, I will make a video to demonstrate this ok.
@@rogerwebbchannel2cncsandmo997 Thank you.
How to activate the +home + option?
is ugs just gcode sender or design too?
You will need Carvec Maker
My CARVECO/ArtCAM 5% discount code is
ROGERWEBB5798
(ONLY AT THIS ADDRESS BELOW)
store-us.carveco.com/collections/roger-webb-discounted-products
store-us.carveco.com/?ref=B40mt_z8N7xiu
Jaskolski Hills