Isometric Projection | Sphere | #8 | KTU Engineering Graphics

This is a detailed explanation about the drawing of isometric projection and isometric view of sphere. Concept of isometric drawing of sphere is explained by using an example.
Facebook Page link / engineeringdrawingbyni...
Telegram Channel Linkt.me/engineeri...
KTU Engineering Graphics Module 4 Isometric projection Playlist link
• Module 4 | Isometric P...
KTU Engineering Graphics Module 3 Section of solids Playlist link • Module 3 - Section of ...
KTU Engineering Graphics Development of Surfaces playlist link
• Module 3 | Developmen...
KTU Engineering Graphics Development of Surfaces of a truncated prism
• Problem No 5 |Developm...
KTU Engineering Graphics Development of Surfaces Introduction
• Development of Surface...
KTU Engineering Graphics Development of Surfaces of a prism
• Development of Prism|...
KTU Engineering Graphics Development of Surfaces of a Cylinder.
• Development of Cylind...
KTU Engineering Graphics Development of Cone
• Development of CONE |...
#KTU #EST110 #EngineeringGraphics #Isometricprojection

[@revands7527]

your explanations are very helpful, thanks a lot

[@engineeringgraphicsktu]

You are welcome!

[@susanjacob937]

amazing class sir . Thank you so much!!

[@engineeringgraphicsktu]

Most welcome!

[@Amegh77]

ty sir

[@engineeringgraphicsktu]

All the best

[@vishnuprasadm6937]

Clearly defined thanku sir

[@LydiaBrune]

Thank you sir ❤

[@maryangel8016]

Best explanation 💯💯Thankyou

[@engineeringgraphicsktu]

Best of luck

[@joeljoy1320]

sir ee drawing sheet il kollan vendi nammuke isometric views inte problemsil scale use cheyan patto

[@815-akhilsanker9]

sir,isometric scaleinte degree engane kandu pidikkum??
aa lineinte same degree aano

[@engineeringgraphicsktu]

isometric scale angle is 15degree and 45 degree.. for concept watch introduction to engineering graphics
ua-cam.com/video/vKui2YfcyFs/v-deo.html

[@Bluemystic_Edits]

25x 1.22 rule aano

[@Siddu_xz]

Yz

[@aslamrahim5935]

Question paper answer cheyoo

[@trollmaker4185]

Sir isometric angle 30 degree alle and true length angle 45 degree alle

[@engineeringgraphicsktu]

Yes

[@Aa_o_da]

Thank u sir ❤

[@engineeringgraphicsktu]

All the best