Programming an Alcohol Sensor with Micro:Bit and the KeyeStudio Sensor Shield.

How to program an Alcohol Sensor using a Micro:Bit and the KeyeStudio Sensor Shield V2.
1. The arduino IDE can be downloaded here:
www.arduino.cc/en/software
IMPORTANT NOTE:
Arduino IDE version 2 does NOT seem to connect up to the Micro:bit with the serial monitor.
After opening the link above, please scroll down and find Arduino IDE 1.8.19, and install this instead.
2. The image of a breathalyzer used in the video was taken from 'Northern Suburbs CLC'- link below:
• You must a breath test...
3. Full details of the 37 in 1 Starter Kit, as well as the project description and a schematic diagram can be found at the link below:
wiki.keyestudio.com/KS0361(KS...
4. You can purchase the 37 in 1 starter kit here:
www.keyestudio.com/products/k...
You may want to watch these videos too:
Programming an LED to 'breathe' with micro bit and the Keyestudio Sensor Shield: • Programming an LED to ...
Programming a Digital Buzzer with micro:bit and the Keyestudio Sensor Shield: • Programming a Digital ...
Programming an LED to flash with micro:bit and the Keyestudio Sensor Shield:
• Programming an LED to ...
Programming a RGB LED to flash different colours on loop using the Keyestudio Sensor Shield:
• Programming a Passive ...
Using a Capacitive Touch Sensor with your Micro:Bit
• Using a Capacitive Tou...
Using a PIR Sensor with your Micro:bit with the Keyestudio Sensor Shield V2
• Using a PIR Sensor wit...
Using a Flame Sensor with a Micro:Bit and the Keyestudio Sensor Shield V2.
• Using a Flame Sensor w...
Using a Crash Sensor with a Micro:Bit and the Keyestudio Sensor Shield V2.
• Using a Crash Sensor w...
Using a Relay with a Micro:Bit and the Keyestudio Sensor Shield V2.
• Using a Relay with a M...
Measuring Light Brightness with Micro:Bit and the Keyestudio Sensor Shield.
• Measuring Light Bright...