For this measuring the solar panel voltage, you can use 0 to 25v DC voltage sensor. You can modify that for measuring hi voltages. I have used it in many videos. Check playlist.
@@sannidhyagupta7026 I strongly doubt it. I could get it to work with 10 Vpeak though, but there was some slight noise on the measured signal. Just beware that the measured signal is phase shifted from the original by almost 90 degrees, so you would not be able to use the sensor for something like closed-loop control.
How can I connect both ACS712 and ZMP101B with a bulb and arduino nano to monitor its voltage and current values? Could anyone help or provide a link for the same?😊
@@ElectroniClinic can you provide me with instructions of how to do that? currently I have one sensor that monitors single phase, but I'm using WH as load which has two phases.
Interesting, as usual. I might use this to auto start a power generator in case of mains failure.
Ya, best idea.
if you have multipe ZMPT101B boards, can you connect them to the same 5V pin?
Thank you for the information. Can you show the same principle with raspberry pi?
can it used in solar panel out put to read the readings , Waiting for power monitoring system video ... Thanks for sharing
For this measuring the solar panel voltage, you can use 0 to 25v DC voltage sensor. You can modify that for measuring hi voltages. I have used it in many videos. Check playlist.
This sensor can be use in monitoring the voltage of hydropower plant?
Where does your range of 80-250v range come from? I can't find it anywhere else on the Internet and would really like to have it verified.
Will it work for lower ranges? I need a sensor to measure small AC voltages (< 1 Vpeak)
@@sannidhyagupta7026 I strongly doubt it. I could get it to work with 10 Vpeak though, but there was some slight noise on the measured signal. Just beware that the measured signal is phase shifted from the original by almost 90 degrees, so you would not be able to use the sensor for something like closed-loop control.
@@richardknipe2733 I use the same 10v peak but no sin wave appear can you tell me why
Thanks, did you upload a video while designing your new arduino development board? I kinder like it 😊
Yes, I have uploaded it. I have explained each and every step.
@@ElectroniClinic thanks, I’ll look for it and watch it several times 😉
Thankyou so much for your video, It is very helpful! Keep The good works !
A nice project
How can I connect both ACS712 and ZMP101B with a bulb and arduino nano to monitor its voltage and current values? Could anyone help or provide a link for the same?😊
Can I measure up to 10 V ac with this module using esp32 and ads1115 ?
Can i measure 80-100vdc with this module?
Can I connect the voltage sensor to pic 16F877 micro controller
which wifi module u using ? i never heard 5km wifi
Is is work for 400-500v range?
I connected as you shown in the video. But I'm not getting correct values, how to solve this ??
Calibrate your sensor. I explained it in the video.
Hi, do you have sensor recomendations for arduino to measure current and watts?
Watch my video on energy meter
can I use two sensors to monitor two phases?
@@othmanmurad5267 yes you can.
@@ElectroniClinic can you provide me with instructions of how to do that? currently I have one sensor that monitors single phase, but I'm using WH as load which has two phases.
Zabardast
❤❤❤❤❤❤❤❤
Wow I never seen this module
This one is super awesome.
Can this detect Frequency ?
No. I have a separate video on frequency monitoring. Kindly, check the playlist.
👌👌👍👍