ABB RVC Setup in AUTO mode

[@mariaeduardaalmeida3356]

thank you, i really needed to see the auto set function, i always got it wrong because i could not wait and other videos usually cut this part of the video

[@aalamaram6030]

TQ sir

[@marcelobarman]

Muito obrigado, me ajudou bastante!

[@satveersinghkashyap6645]

Very good

[@dyonedantasrodrigues3154]

Show!

[@AleshaJohan]

Sir, I have problem when conduct auto set, error' code F1, I have removed CT bridge, but still error F1, is there any solution?

[@SukhjinderSingh-po9fl]

Sir what is the minimum ampere required to operate apfc in auto mode.
And what is F-1 code

[@unirax8628]

take load not less than30%

[@conceptelectionics7773]

Yes SpenXor is right minimun 30% of Load current is required to Configure RVC in Auto Mode. Error F-1 stands for 'Current too small.'

[@ryanmamase5476]

Where are you...discription...?

[@conceptelectionics7773]

This was taken at a very noisy site. We will upload a new video shortly with instructions! Thanks for the feedback

[@ryanmamase5476]

@@conceptelectionics7773 ok..thanks...