КОМЕНТАРІ •

  • @alfredace
    @alfredace Рік тому +2

    Hello! This video is very informative. I will be performing the same work on my 2008 Accord coupe this weekend.
    How many NM of torque do the 10mm bolts get?

    • @kitlacaden
      @kitlacaden Рік тому +2

      11.NM and torque w/ sequence ;)

    • @alfredace
      @alfredace Рік тому +1

      @@kitlacaden Thank you sir!

  • @romanrebisz4205
    @romanrebisz4205 10 місяців тому +2

    How do you take it out

    • @kitlacaden
      @kitlacaden 10 місяців тому

      Just take it out.. little bit tricky need to puzzled..

  • @NJRt461
    @NJRt461 Рік тому +1

    👍👍👍. Good job. This could be my next project for the Acura MDX since I suspect the seal is leaking. I have seen minor (just a few drops) oil leaks from the bottom on front end of engine block near the exhaust manifold. The oil drips on the front engine mount and exhaust pipe so I smell oil burning. I have replaced valve cover and grommet gaskets, front camshaft cover seal and found no leak on any other common leaking areas of this J engine. Did I miss anything in your experience? Is it possible oil leaks from the manifold gaskets because I reuse the old one? Also I can hear engine hassle noise while acceleration.

    • @kitlacaden
      @kitlacaden Рік тому +1

      No problem with your exhaust manifold gasket, because no oil running in exhaust manifold... maybe you did not clean the old leaks thats why you smell burning oil when you use your car. ;)

    • @kitlacaden
      @kitlacaden Рік тому +1

      About the noise.. try to check your drive belt. Auto tensioner or idler pulley..

    • @NJRt461
      @NJRt461 Рік тому

      @@kitlacaden no noise when idle. Hear noise at over ~20 km per hour. I replace power steering o-ring but no helps.

    • @NJRt461
      @NJRt461 Рік тому

      Thank you so Much👍👍👍👍👍👍.
      I see this VVT solenoid gasket leak on Honda but my 2001 MDX is different. I may need to inject some dye to see where is leaking.ua-cam.com/video/AmK_AdtVuZA/v-deo.html

    • @kitlacaden
      @kitlacaden Рік тому +1

      In v6 engine.. replace vtec solenoid valve assembly if leaking..

  • @vendrabagus3074
    @vendrabagus3074 5 місяців тому

    how to remove on rb1

  • @sinofpride8516
    @sinofpride8516 19 днів тому

    Lowkey this video is pointless. All your showing is screwing in the oil pan no steps on how to get to it or what you need to remove to get to it