Zero point calibration Toyota

[@puerco567]

Se borra y cuando la muevo y cambia a 2da velocidad regresa el error, que sera?

[@luisfernandoduquesalazar5867]

Si tu carro tiene el código C1336 no lo puedes borrar así tiene que ser con un escaner

[@abaakwa968]

Please sir am a car marcanic how about if the light did blink what is the problem?

[@arturogutierrez4427]

Y para una sequoia 2001??

[@pintosautoymotosfix]

Intente esto: Zero point Calibration ZPC
1. Center steering wheel
2. Short Ts and CG
3. Start engine and wait 4 sec
4. move steering wheel more than 5 deg and then re-center.
5. quickly press TRAC OFF button 3 times (within 3 sec)
6. long beep = success ZPC complete
7. turn off remove jumper

[@pintosautoymotosfix]

Ts = 1
Tc = 2
CG = 3
.....__.....
XX12XXXX
XXXX3XXX sorry for the crude dwg. Look to see where pins are it helps. It isn't full.

[@arturogutierrez4427]

Donde esta tu taller

[@pintosautoymotosfix]

Ts = 1
Tc = 2
CG = 3
.....__.....
XX12XXXX
XXXX3XXX sorry for the crude dwg. Look to see where pins are it helps. It isn't full.