Hyundai Elantra: How to change the gearbox oil with a manual transmission 2007, 2008, 2009, 2010

Поділитися
Вставка
  • Опубліковано 9 вер 2019
  • How to change the gearbox oil / fluid with a manual transmission with a Hyundai Elantra model year 2007, 2008, 2009, 2010.

КОМЕНТАРІ • 21

  • @jesusdrummer21
    @jesusdrummer21 4 роки тому +2

    Watched your video. Got under my car. Where is drain plug? Found it. What a beech getting the filler hole nut off. Had to kick it with a wrench. Went to Dealership got 3 quarts for only 28.00.. all went well because of your video thanks

  • @MadeInUSSR75
    @MadeInUSSR75 3 роки тому

    Awesome advises. Best so far I could find online. Thank you.

  • @nulife022
    @nulife022 4 роки тому +2

    Thanks, helped a lot

  • @user-zk1xf4tx1w
    @user-zk1xf4tx1w 3 роки тому

    My Kia Cerato 1.6M 5-sp same identical plc as your Hyundai Elantra. Thx bro!

  • @MisakiNyu
    @MisakiNyu 4 роки тому

    Thank you very much

  • @USSHammerology
    @USSHammerology Рік тому

    Thank you!

  • @jacekkarp7701
    @jacekkarp7701 3 роки тому

    Thank you

  • @AncientAliens5
    @AncientAliens5 3 роки тому

    Here's a tip. I have a 2007 hyundai Elantra. I figure it's better to just wait until the transmission fluid gets low and then add more through the red A/T dipstick hole with a skinny funnel then you can check the level by following the owner manual for the car and (siphon "remove") fluid with a skinny tube or add fluid as necessary and do it all through the dipstick hole. This is what I did and it worked. Just make sure you are exactly even with the HOT line on the dipstick.

    • @bored1980
      @bored1980  3 роки тому +2

      Yes, that would work with an automatic transmission.

  • @johnstrato9795
    @johnstrato9795 4 роки тому

    Hi, Good Video. Very Clear. I have an i30, on top of the gearbox there is a breather. It looks oily. If I want to remove it to wash, does it unscrew or are they a push fit. Or should i leave it in place and wash with a small amount of meths (before i change the oil in the gear box)?

  • @theresahernandez5387
    @theresahernandez5387 3 роки тому

    I replaced the master cylinder on my car but now it wont catch first gear. What do u think cld be the problem?

  • @dennispark2992
    @dennispark2992 3 роки тому

    Should I just fill it up until it comes out of the input whole to know its full

  • @seniorprogrammer7585
    @seniorprogrammer7585 Рік тому

    What is the size of drain and fill plug washers?

  • @LifeOfDeeG
    @LifeOfDeeG Рік тому

    Is there a filter that needs to be changed?

  • @poppopkrypton1136
    @poppopkrypton1136 3 роки тому

    Son-in-law's 2008 Hyundai Elantra is having loud whirring noise when in gear. I will try the fluid change tomorrow. How is your Hyundai manual transmission doing, so far?

  • @hasifnasrullah5426
    @hasifnasrullah5426 4 роки тому +2

    Hi there, can I use Castrol 85w-90 GL4? Your help would be greatly appreciated. Thanks!

    • @bored1980
      @bored1980  4 роки тому +1

      It's a good question and I was asking the same when I did my oil change, because the 'official' oil is quite expensive. The answers I received were all different, so I can't really give you a concrete reply. My advice (to play it safe) would be to invest in the same RedLine MT-85 oil I used. It's more expensive, but it's exactly what Hyundai recommend. I hope that helps.

  • @zaiser9
    @zaiser9 4 роки тому +2

    Did you reuse the washers or replace with new?