Car Hifi: Installing amps, subs, speakers Honda CR-V
Вставка
- Опубліковано 1 вер 2015
- A quick round-up of the installation of an aftermarket active subwoofer into my 2014 Honda CR-V, 4th Generation, Lifestyle Edition. Wiring from battery, ground, getting the audio signal are covered. Components: Eton USB 6.2 active subwoofer
- Авто та транспорт
Thank you the only video that shows how to do this for the Honda CR-V (2012-2015)
Thank you, this is very helpful. You sound amazing for not being a native English speaker! I am blown away. 🤙🏻🙏🏻☺️
Thank you! 😃
The cheat sheet is so cool! Your English is very nice for not being a native speaker! Great video
This is intended as constructive criticism not trying to bash the guy, however I watched the first 2 minutes and I saw some things that I think could be improved upon.
1. the location of the fuse, I would shorten the wire between the battery terminal and the fuze. the fuze is there to protect the wire, if the wire shorts it will heat up, and since the wire is run across the top of the battery, the wire will melt the casing of the battery causing further problems.
2 the location of the fuze on top of the negative terminal, not good, and since the wire is not protected, eventually the heat and vibration from the engine will degrade the insulation and short out.....etc.
3. I would recommend using non-metalic to fish wires through the firewall of the car. it is just good practice, a big ziptie can make a good one.
Like I said I am not trying to criticize, but I think he would be better off with these changes.
Everything you said is correct. The power wire going to the fuse should be shorter. If let say the wire comes loose from the fuse holder, the wire can reach a ground part of the car or the batteried negative terminal and burn the wire and or çause a fire...so hopefully he trimmed the power wire to the fuse and he remounted that fuse block better.
Hey nice job ! It's funny how people that are learning to speak English get the " fuck " word quickly without having to write it down. LoL.
Those are 2 x 6.5 in speakers, not 10's as stated. Otherwise, the video is great! Thanks for the valuable information!
Those aren’t 6.5 inch speakers your dumb
what is the color of the subwoofer wiring before the green and black is it bkue and pink
Does the subwoofer amplifier use such a large amount of current that you need to connect directly to the battery??!!
Hi, I would like to change the front doors speakers. Do you know what is the deepness size max of the new speakers in can put in to replace the original speeker. Can you help?
I know this is very old now, but i couldn't tell where you started in the engine bay, you just said "the rubber element" , was it some part of the clutch pedal? What rubber element? I am trying to do the same job right now. Many thanks.
what kind of connection did you use to connect the low level from the old sub to the new?
can you eleborate more in the signal wiring. im trying to hook up a 2 channel powered sub. thanks
So power wire from the battery of course, ground, for the remote wire you tap in to the remote for the factory amp under the passenger seat to turn on your amp, then run speaker wire from YOUR AMP to the factory sub wires as shown THEN from there to YOUR subs?
Nice!
I've got no sound on my cr-v 2014 sr, just installed sony xav-ax3005db with connects2 CTSHO006.2 cable, I didn't know mine got factory sub/amp as it was originally no navigation unit.
Don't how to make it work :(
Which one is the positive for speaker wire from the sub? Green or black: I`m guessing green is +
Your English is better than some Americans I know
+headunits Better than a *lot* of Americans I know. lol
Looks like we have the same taste in music. What song is this?
so you get a clean sub signal without using a line output converter or audio control lc2i ?
Yes, I grab the (already bass only) signal that goes into the factory amp.
Sir. Vidio was very helpful. Explained alot. Do have 2 questions. Got 2011 crv w/o navigation. Have amp with 2 subs in box hooked up.Want to dissconect sub under seat and use plug. Same way ? Kind of new at this.
Hello, I have a CRV 2018 And we installed an amplifier and a 12-inch woofer, the problem is that when we pass the 2000 revolutions of speed a noise comes out with the stereo in low volume, we have to raise it to be removed, but it is very annoying, the amplifier is also small, it is JVC of 600Wts.
sounds like a bad ground issue
The problem ís that HONDA'S without a built in subwoofer have an ANC (Active Noise Control) Unit and you would need to unplug it under / on the side of glove compartment. That noise you are hearing is like a humming noise that this ANC is sending to the speakers to try to cancel out road noise. To not hear that noise again, you should disable the ANC Unit by disconnecting the wire harness to the Unit. I also have an 2018 and I am planning to install an amp and sub but before I do my installation, I unplugged that wire harness to the ANC Unit.
Thanks brot👍🏼👍🏼👍🏼
Welcome 👍
speaker size?
hey! do you know which one in the factory sub is ground or power?
"where the fuck did i put that?"
native enough!
Hey man I know this is super old but for future reference hit you solder joint with a torch, that cold solder job you have will fail eventually. Thanks for the video
Thanks for the tip!
Do you know if the wires coming from the subwoofer are pre-amp line levels or are they speaker levels? The reason I ask is that the factory subwoofer has other wires going into it that might be powering it. This is the only information missing from this video. It will effect how I wire it up to my aftermarket sub. Otherwise, very helpful thanks!
Figured it out. Looked at CRV wiring diagram and it depends on your model. Green wires = speaker level wires. Purple wires = preamp wires.
@@dmeskill2 hey man thanks for this, probably the most helpful part of the whole video
where is the remote wire?
I would think it would be in the head unit itself considering it's still a stock head unit
Indeed, it comes with the sub and goes directly from it. No connecting to car peripherie has to be done.
What did you use to crimp the two sets of wires together?
Thanks!
Where can I get those subs? What brand?
It's an ETON USB 10.
little windy there lol
Are those heated clothed seats?
yeah
Future reference, your metal coat hanger should not get close to the red positive battery terminal and the metal chassis of the car. You could have electricuted yourself. So be careful when holding metal near the battery terminals.
Not electrocute with 12V but cause short circuit, arcing, hardly unlikely 💥.
Those are not 10'
Those are not 10's. Maybe 10 mm 😂😂
You should have cleaned your car before filming...just saying.