Charging Automobile Battery using Inverter Welding Machine
Вставка
- Опубліковано 8 вер 2024
- Charging the battery using Inverter Welding Machine.
First you have to open all the battery covers then put battery solution up to it's normal level
As the battery is charging, keep the battery open so that it will not explode as the sulfuric acid starts to boil
Charge the battery for 1 hour
Boss ginawa ko din ito nag charge nga siya pero kina umagahan nag low batt na naman siguro need na magpalit talaga ng battery, pero salamat pa din sa video more power sa channel mo boss.
La próxima vez que haga este tipo de videos, asegúrese de explicar bien cuál es el voltaje que debe entrar a la batería, el amperaje y cuánto tiempo debe de dejarse conectado el inversor a la batería, también si se necesita una resistencia adicional o algún otro elemento que ayude a que cargar la batería de este modo sea seguro.
O si simplemente se conectan los cables directamente a los bornes de la batería al positivo y al negativo
A nice and sweet video on the subject matter at hand.
This is very dangerous. The output voltage of the welder is around 60v or more. The battery needed only 14v, so is it safe...???
Firstly it should not charged for one hour . 5 min to dissolve the sulphate crystal s then before put the welder as charger check the void reading
If it fall s below .60 amp it's very dangerous
Check your reading with multimeter every 5 mins any difference in increase play safe
Does this work
What's the output voltage of your welding machine ?? You used to charge or revive a battery???
great will check and see the result
I got a matweld 200 DC welder and it wont work,why is that? Thank you
I have also tried mean using ronix RH4604 MODEL 200a but didn't work out i tried on two other batteries but no boiling effects 😢😢
It only means that your batteries are dead
The voltage must be 20v to 80v. I think he's only charge it for 5 mins in 20AMP....
What were the results?
I have a full charged battery, like brand new.