Відео

Tik much talking....

FFS bmw just put a temp gauge in

This was an amazing video! thank you for sharing!

One piece of warning to everyone: Two of my glow plugs snapped while taking them out. To prevent this tighten them just a little before loosening them all the way out. Use a regular ratchet. Also you can warm the engine up and use a vit of pb blaster for each plug. If you snap off the glow plug you have to push them through into the cylinder and fish them out apparently through the injectors. That didn't work for me and now I have a small piece of glow plug in my cylinder.

Thank you very much for this demonstration. I was not inclined to try this myself, as the folks at the garage gave me the impression that this is much more complicated/difficult than it is. Won't let them gouge me on this service again!

Well, it was almost painful to watch. I’ll just leave it at that..

Can it be done on an N57?

Thank you.

Thank you SO MUCH!!! I was ready to pay 2K for a new unit... boy, do I feel happy and stupid... :-) BTW, you can use 1/2G DEF bottles, as a handy funnel by removing the bottom part of the bottle.

Gracias por el Video , Muy Bien

Do you have to take the EGR cooler off to access the thermostat?

Holy crap how many umms do you say in a day

I just bought a 2012. X5 with the 3.0. It blew a head gasket. I deleted egr. Still made water in oil. It has 142, 000 miles. Would it make sense to do the head gasket and to service everything on top of engine when doing the Head gasket? What I am asking are these engines able to be fixed?

have you ever done the NOX sensors?

Can you tell me where you got the refill bottles from. I checked on Amazon and while there is a BMW listed version it doesn't seem to state that X5 is covered/compatible.

Thanks you good job

Have you ever used a DPF cleaning fluid flush?

Thank you

Great ,can you share the part number ?

❤❤❤❤❤❤Thank you!

46ft lbs for the bottom bolt of the strut to the trailing arm?! Are you sure?

You mentioned the original BMW oil, but the oil that you have listed is Castrol. Is there are not a difference in those two oils

“Lemme get my screwdriver” *Grabs massive yellow construction pry bar*

im gonna have to do this job soon. doesn't look very fun but ill be using this video to help me out. thanks!

It's better to install obd display, but i need transmission temperature which not available in my obd display

Have you test at 1080p with video mode at night?

Did the other side cable unscrew the same as the one you showed us, just thinking of having a go at mine, Regards

Very well done this is the only video I found on def tanks

Great video I will have to do mine aswell very soon! For a constructive criticism you said the the filler word "hummm" at every 3 seconds and found it hard to keep track of what you were saying during instructions. Don't take it the wrong way, you can only get better!

No mention of torque specs anywhere.

Every mechanic in the world: “look at my big hands”

How many litres shall we put in ?

Tell me the falut code P 204F reductant performance bank1 2012 e70 X5 35D

How did you know is actuator and not the module?

Thank you, I followed the video and got the jobe done.

Thanks for the video i just did it last night

My T45 bolts are STUCK- any advice?

Uh, um this is unwatchable with sound. I appreciate the effort though.

Good morning, a question, you only have one tank, I have that problem, the level of both tanks does not go down the same, the level on the driver's side goes down more slowly.

Forget the haters, great video here, very helpful

Left dealer after first service a quart low. Thanks for dip stick. Information center said it was full. Castrol is the recommended oil however Amsoil has a better oil for this diesel car.

ummm uhhh

If only the spring of the cooler is broken, you don't have to buy a new cooler. Just buy a small spring from Homedepot. Attach one end to the plastic arm. Attach another end to the body of the car.

The umm learn a new word please theumm

I did this exact job and got everything back together. Now my car goes in and out of limp mode. Eventually I got a code for excessive flow in EGR. Im wondering what I might have done wrong???

Bravo

what parts store you used to order?

Paid £1,200 devastated

Really clueless guy, total non-sense coming out his mouth. Lucky as can be

Ты реально тупой ! Ты не можешь снять планку которая выходит оттуда без проблем !😂😂😂