Відео

3 years later and nobody has found a better way to do it. I feel like it would be easy enough to wire up.

Hell yes!!! Thank you just what I was looking for. I'm fabricating a dual turbo exhaust out the bottom back of the front fenders and needed to move the PCM/ECM but wasn't sure how to approach it.

Came on clutch THANK YOUUU!

Any power gains with this set up?

Thank you. I had bought a twisted shifterz knob and had no idea it had a lock pin in it. I thought it just twisted off like my ws6 knob did. This was short and to the point. Had me back rowing in 10 mins.

Nice job making your own version and talking time to make this video on steps to make it work. I will keep it in case I decide to change to LEDs. Thank you

Can you enable it again?

So, it will fishtail and run into crowds like a Mustang?

Your content is awesome 👍 my dream is a supercharged c5 with a wing. Keep up the grind dude

Shit song and car.

Which coil overs are those ? I have civic ferio 4wd . Thanks I. Advance

What’s the bolt pattern on the orthia ?

About time

So sick brehhh

Looking forward for the rx8 build👌

Ooooo neat

Same process I went through after tearing down the old one first. Mine is pretty much an identical design, except I used steel trusses on 6x6 posts.

That wheel is sick

That hood ornament is not for everyone 😅

Dope shop bro! If you wanna grow your channel, faster cuts on content, bring up the energy when talking, gotta seem enthusiastic about EVERYTHING lol.

Brother. Thank you for making a quick to the point tutorial style video. This was very informative without any bs. Thank you.

would this flair fit the c4? soecifically 1988 corvette

I just picked up an Orthia that need some suspension work and this video was super helpful. Thank you for making this I will be referencing it over then next few weeks.

Hey, I'm not sure if you're still on here. Could you explain how you made the fuse with the two clamps on it??

Everyone saying oh its tacky, etc. I too was thinking that until I realised this is a DRIFT car build and NOT a show car. Makes perfect sense cos those dudes hit shit, remove and replace. Yeah it looks tacky not blended in but like I said... DRIFT CAR. This is as good as it gets for that!!

My polymatrix E are trash

Does this mean you don’t have to repair the ebcm ?

If I did that I'd glass then on, do the bodywork and repaint so no dumb looking screws.

This guy is a beast🎉🎉🎉

This is where it should of been from factory

Easy. Just buy a 2000 or earlier, chances are it is already permanently disabled. I know mine is.

Dude! shout out to you for the part numbers and everything!

What do you do with the codes you get after 5his???

You should do shit like that to the fugly c4, not the c5...

Seth - need some work on the video, can’t tell what you’re doing.

Tonight bad idea 😂😂😂

Nice bruh

Lmao I fux wit it…

Is there a way to get that abs light off after you do what you did

😅😂😅😂

Now that's funny, don't care who you are.

What do the right two taillights say?

No one drinks that piss water anymore.

LMAO🤣🤣🤣🤣🤣

Nobody wants their queer beer.

The audacity of this burn 😂😂😂😂😂😂😂

He finally came out

😂😂😂😂😂😂gold

lol

🤣😆🤣