- 8
- 31 685
Ryan
Приєднався 19 лис 2012
I try to keep content limited to things that I could not find a clear cut answer online. Thanks for watching boys and girls.
Mower battery revived with reverse charging.
I forgot to mention that this is only for a battery that won't take a charge, not a battery you accidentally ran dead. credit to Garage 54 for the idea.
Переглядів: 579
Відео
Cub Cadet Intellipower 547cc running rich solved.
Переглядів 2063 місяці тому
I was ready to put a manual carb on this unit until I had one more go at the carburetor and found the issue was the plastic valve under the steppers. the o-rings appear to be of the incorrect type of rubber and were eroded away. replacing the o-rings fixed the issue with running rich. this mower is on old gas so I would say a new tank of gas and a new spark plug and it should be back up and run...
toyota corolla 1.8 no reverse solved pt2
Переглядів 12 тис.2 роки тому
toyota corolla 1.8 no reverse solved pt2
Re-keying your Ford focus hatchback lock.
Переглядів 232 роки тому
this video shows how to remove the Tumbler assembly from an 00-04 zx3/zx5 Bosch hatch lock/striker adsembly and install it on your new latch.
Jeep Liberty 42rle to 45rfe and 4x4 upgrade part 2
Переглядів 3414 роки тому
Jeep Liberty 42rle to 45rfe and 4x4 upgrade part 2
Jeep liberty 42rle to 45rfe and 4x4 upgrade part 1
Переглядів 2,3 тис.4 роки тому
Part 2 of a 3 part series showing how to swap a 42rle with a 45rfe in a jeep liberty that came with either from the factory depending on year. EDIT: 6:25 I said crank position sensor. I meant reluctor wheel. You have to pull the crank for this. EDIT: 10:41 R is rear wheel drive L is longitudinal (as in longitudinal vs transverse)
2002 jeep liberty wiring harness issues resolved
Переглядів 1,8 тис.4 роки тому
Turn signal, air bags, and fuel gauge was not working.
What tool do you use to get the planetary out to get the the lower reverse clutches
Also having trouble taking my last wire out of the orange solenoid input tried using a flat head. Same for my planetary but cant get it out. Im guess i gotta take the plug out first when i take the valve body off correct?
Why Corolla 2010 automatic gearbox transmission not enter rivers again after service the verve block
Check the low reverse clutches.
do the components just slides off or do you need speacial tool?
As best I can remember I didn't use any specialty tools for this.
What was the fault issue i didn’t understand
How many miles were on your machine before you took it apart? If you don’t mind me asking.
Something like 190k
I did not mention in the video that that small metal/rubber pipe that goes between the valve body and the brake clutch requires you to drop the valve body or you'll cut the rubber part of the pipe
Hi Ryan, do you need to replace this pipe when replacing these reverse clutch pack?
Only if it's damaged @@westcoastreefer
How do you get that pipe out with pilers cause i cant pull it out or get the 2nd brake housing out to get to my low reverse clutch plates
I had the same exact problem as you even with the chipped teeth of the ring gear. I did what you did and got my car running again. Thank you so much for this repair I was actually thinking of replacing but did not feel up to that fight either. I have noticed now that I am having a clunk when the transmission goes from 1st to 2nd gear and was wondering if you may have an idea of as how to fix that. I will be going into the transmission again soon when I get the replacement gear ring.
I'm glad I could help. Still have no idea how it happened
Check the small rubber/steel pipe that connects the valve body to the 2nd gear clutch (that large aluminum ring) i found out the hard way that you have to drop the valve body to fix it
Part number 3515921010 (35159-21010) TOYOTA Gasket brake drum your best bet is order from the dealer. They may have an updated part number but it's that part
What year is the car
My car suddenly makes a lot of noise when shifting gears and ever since yesterday it just stopped reversing, it does so for like 1 ft and then stops aggressively
Got mine in the same spot. Field rat. Little brown bastard LOL
What year Corolla is it?
2009
My car corolla Revas problem not moveing
My also ! What can be the issue?
How are you good
Hi
Is that an auto transmission?
Yes u341 I think
did this fix it?
It did. Been a year and still going strong
Can you give me link to where you looked it up at? For the reverse clutches
Search 127114a on wittrans.com
Thank you.
You're welcome.
That funny I had squirrel get in mine and he gnawed my wire harness off my right turn signal all the way to the nylon bulb housings. Also the 02-04 models are notorious for their electrical issues and substandard window motors.
...and once 45rfe, can youpgrade to 65rfe?? just guessing
If the harness is the same and the TCM is the same I don't see why not but the stock 45rfe is plenty adequate for the 3.7 power tech
@@SuicideSlushie Thank you so much for your kindness and support, so appreciated!!
If you're doing all this work to swap transmissions why not swap the 545 and a 4.7 and get rid of the 3.7??
@@somewhathilarious95 Thank you very much, that's a very good point
Fucken eh...i bought an 02 donor for my 06 cause i needed the transfer-case & engine oil pan. Swapped those but ever since i've been looking at the 45rfe & wondering what i'd need to swap it in place of my 42rle. This was a huge heap of info thanx for doin the leg work guy. I mucho appreciate it. If you got any updates or anything real important you've figured out since...i'd be more than interested to know. Thanx again!
I actually sold this car and it's still going strong. The only issue is that the 2wd front springs arent stiff enough for the extra weight of a differential and transfer case but if you already have a 4x4 I dont think it'll matter
Reverse light also wasnt working. It is working now.