Відео

Interesting

Hoping you enjoyed the "dildo V2 magnifying glass" lolz @8:22

Dont print it sucks. Literally scrapes the texture off the plate

Screws are on the wrong side mate, screws should touch the blade, and extend in to the other piece as shown in the picture on the X1C screen.

Can you get the blades somewhere else? Bambu Lab charges $10 for 3 of them.

Get the texture plate ,no glue stick

I have been trying to figure out where the scraper is mounted on the X1 Carbon, it seems that it can only be mounted on the back panel just like the single spool holder, I hope Bambu Lab learn the meaning of ergonomics next year LOL!

Is it possible to share the PPT?

Maybe sent by the cloud, look what's happened to others

The small piece that the screws go into should be on the bottom of the handle. I tried to do the same thing but realised the holes didn't line up. The screws should be touching the blade directly.

Looks good, thanks for sharing it with everyone!

poor plastic gears next time take ptfe tube off on back going in printer pull slightly on filament and press retry it will retract

am finding it doesn't quite fit. I have to do the same with the screws being partially in but the plastic gives out before it can tighten the screws all the way in and the piece can't adequately tighten the razor. do I need to reprint?

Is glue stick nescassary with pla?

you do not have to wash it every time and for the times you need to clean it use some windex, it desolves gluestick, and after just wipe down with some isopropyl alcohol.

Im saving up for this I think I will buy it as my own birthday gift in June

Don’t run the carbon fibre in you ams

You bend the plate to remove part

You can select the colors you are using in the interface or cell/pc software. Plus you don't have to wash it every time you use it, I dont even use glue, I use hair spray instead. You add glue or hair spray and you are good for at least 10 prints with out adding more, after maybe 20 prints I clean my bed and add more hair spray. and make sure you leave room behind the printer for the poop hole

Great overview of the process ! I am new to the hobby and getting ready to purchase my first printer. Would you happen to know the total height of the Bambu. From base to top of AMS? Keep up the great work

I'm surprised it printed mine wont print with plate not correct lidar stops it and its flex bed u just slightly bend the bed to pop stuff off in most cases

Quick heads up, you have the build plate in sideways. The little tab that stick out should be at the back, as it needed to wipe the nozzle on. The QR Codes and PLA text should be at the front.

You can bend/flex the build plate and the parts (especially bigger parts) will pop right off.

Another great example of one of many ways to acquiring one of the key means to survival in any environment.

How much was this?

Lucky!