Відео

@@harveynguyen-cg4cv It extruded straight down so I thought it wasn't a partial clog though

@ check if your nozzle size matches with your slicer’s settings

@ if it is, it might just be because your filament is humid with too much water in it

@ you can buy a box that kind of dries your filament

@@harveynguyen-cg4cv the fillament is definitely humid. No doubt about that. But the facts ramains that this defect is only on tall and thin prints. No over extrusion or under extrusion from humidity. All the walls are smooth. As you can see, the lowet section is clean, but the upper section got snagged by the tool head and wiggle around when printed. It happend so often that I'm willing to look into y-axis acceleration so that the model don't jitter so much

@@harveynguyen-cg4cv I print PETG at 350°C. Maybe it is due to the fact that the part is flimsy, 3x3mm to be exact. This is one of the main drawbacks of the bed slinger design. Tall prints got shaken like it's an earthquake demo =))). I'm adjusting the design to combat this

@ thats good, i hope i helped

@@harveynguyen-cg4cv you definitely did. The fact that you commented made my day. Sta tune for v2.1 =)))

@@KAMI_24 you took the word right out of my mouth. Thank you for the suggestions. That is what I will do for version 2 after I realized that I need to come to the back and manually plug in the cables HDMI and thunderbolt cables 🤣

@@jf8322 fair point, I just overkill it a little bit 😅

@@timmyboi6882 0.06 layer height =))

@Leviathan0707 why would you print it at that layerheight seems like a waste of time brother

@timmyboi6882 I appreciate the finish on products that I intend to last a long time. It will be mounted on the frame of the printer afterall so I would like it to have a nice finish.

@@Leviathan0707 lower layer hights doesn't help all that much with strength, and that part dont need less than .2mm layer hight. there is no curves that would benefit from verry low layer hights.

@andreasklbo3895 point taken on the vericality that don't need small layer height. That's fair. Should have gone for 0.1mm. Other than that, I just like a smother surface to result in less sanding. Although it might look fine for now. Once I put primer on it will show. Thanks for the input btw. I completely forgot about that

@@omaroskeno3314 yea, I was expecting the AI stuff on the A1 to stop it but I have to stop it by hand all the time. 5 FPS is really bad but for a spaghetti it is really easy to see imo. As long as the lighting is sufficient ofc

Yea man, but I didn't expect it to hang this far without any support. That's mind blowing 🔥🔥🔥

Watashi ni Tenshi ga Maiorita!