Відео

I have lost the info the top half of the engine is a close copy to the Elgin engines the bottom base is diffrent from any other They were cast in Fortierville Quebec at the Bernard foundry go to my community i found a not so clear add

It is very very very similar to a Maytag, is it a 2 cycle?

@@deepsouth-piddlin Yes it is 2 cycle go to my community there is a ad from 1917

Yes black again a few parts went missing 30 plus years ago but anything needed can be bought in the UK gave a fast sanding on gas tank to find the paint that was there no pictures when i bought it

thanks just got from a 3 day show had it with me most it ever ran

I got a 1 hp going for someone years ago this one is starting to run well the rings were stuck they are starting to set back into place .have only ran it a couple of hours .this engine almost went to scrap saved by a few days

Good save! It's amazing how much is still being scrapped or thrown in the trash. A friend of mine saved a fairly nice Admiral console stereo from the 60's that was just set out on the curb for the trash right before a hard rain hit. Sounds great and only had a wire loose.

took ideas from other engines

not sure on the hours he did it over a winter the video should have been longer don't see all the moving parts

www.dippy.ca/how.htm

it 's two stroke oil same mix as in the BEBE and it's smoking away

😂 so did I

yes man.... 🤗

John your would look the same with a rough cut board I just modified a spark plug some day it will have a igniter inside piston trip

​@@brianperiard495 здравствуйте не могли бы разобрать и показать подробно принцип работу ,я б тоже Очень хотел такой собрать но увы опыта нет ,и в технике понимаю не много ,я был бы рад если б вы мне помогли !Спасибо

Not able to show it apart runs to good and all joints Loctite @@qwertyqwertyx8188

​@@brianperiard495ну тогда не могли бы хоть чертеж нарисовать я очень хочу такой 😢

this is the guy that sells the plans with good DVD to show all Leon Ridenour 4610 Sunflower Road Knoxville, TN 37909 865-584-9759

Jozsef contact Leon he has the full plans and dvd Leon Ridenour lives in Knoxville, Tenn., and can be reached at (865) 584-9759

Good day here is the contact info great plans and DVD to show diffrant set up om mill Leon Ridenour 4610 Sunflower Road Knoxville, TN 37909 865-584-9759 Leonhfordone@gmail.com

@@brianperiard495 Thank you for the info. Finished parts such as gears, ignition, cylinders are not available as semi-finished products, are they? Sorry for my bad english translated by google. Greetings from Germany Rene

@@zeresamadine Rene he just gives plans but he might have some parts as cylinder and piston he will give info where to get what you need You will need machining tools to do this Good Luck

@@brianperiard495 Thank you for the info I will contact him. Greetings Rene

@Brian Periard Hello Brian, I received the building instructions from Leon with a CD. He could not send any parts. My question to you is your flywheel the same size as written in the instructions or how big is yours? Greetings René

Still have it got it about 8 years ago decided last year to clean out the tank and got it to run

Hello sir.would you know how much an engine like this is worth? Cheers

@@Daithi16 I would think around 6to 8000 us