Steve Smith
Steve Smith
  • 14
  • 130 221
Ford Focus 2008 Rear Stabilizer Bar Link Replacement
Ford Focus 2008 rear Stabilizer Bar Link Replacement
Переглядів: 14 950

Відео

Mitsubishi Colt gearbox oil change
Переглядів 21 тис.3 роки тому
Mitsubishi Colt gearbox oil change
Opel Astra J 1.4 Coolant Leak Repair
Переглядів 30 тис.3 роки тому
Opel Astra J 1.4 Coolant Leak Repair
Opel Corsa front brake part II
Переглядів 113 роки тому
Opel Corsa front brake part II
Opel Corsa front brake job part I
Переглядів 173 роки тому
Opel Corsa front brake job part I
Nissan Qashqai blower resistor change
Переглядів 57 тис.3 роки тому
Nissan Qashqai blower resistor change
Subaru XV Crosstrek key fob battery replacement
Переглядів 3,2 тис.3 роки тому
Subaru XV Crosstrek key fob battery replacement
Subaru XV Crosstrek 2018 Air filter change
Переглядів 2384 роки тому
Subaru XV MY 2018 air filter change
VW Passat CC 2 0 TDI Oil and filters change
Переглядів 2,2 тис.4 роки тому
VW Passat CC 2 0 TDI Oil and filters change
Kia Rio oil and air filter 1st part
Переглядів 684 роки тому
Kia Rio oil and air filter 1st part
Hydraulic Press 20 T
Переглядів 764 роки тому
Hydraulic Press 20 T
Subaru XV 2018 LED licence plate lights
Переглядів 3674 роки тому
Subaru XV 2018 LED licence plate lights
VW Golf 5 1.4 FSI Oil service and air filter change
Переглядів 1,1 тис.4 роки тому
VW Golf 1.4 FSI OIL service
Peugeot 306 fékcsere előtti méretellenőrzés
Переглядів 1354 роки тому
Peugeot 306 műszaki vizsga előtti fékcsere előkészítése

КОМЕНТАРІ

  • @tsnudhaube
    @tsnudhaube 2 місяці тому

    Thanks for the video... I got a cheap aftermarket replacement hose, but it was not a good fit and still leaking. The old one looked good except for the O-ring which was damaged. So I took the O-ring from the new one and fitted it to the old hose... everything is perfect now! Thanks to your video, I had someone with me who had his thumb on the cooler connector, so the spill was minimized.

  • @VLG105
    @VLG105 3 місяці тому

    Nice video, helps me out with my colt czc that i want to do this to. One thing though, always make sure that you can undo the filler plug first before draining the oil. You don't want to find its seized. Ask me how I know lol.

  • @Hello_there_obi
    @Hello_there_obi 4 місяці тому

    Do you keep filling until it overflows?

    • @dentyx
      @dentyx 4 місяці тому

      1.75 litres it takes

  • @MattSR500
    @MattSR500 4 місяці тому

    Thanks, I'm about to do the same job and this is very helpful. What oil did you use?

    • @Hello_there_obi
      @Hello_there_obi 4 місяці тому

      If it helps, I have a 2009 1.3L cleartec and it uses 75W-90. But it varies across engine variants so just cal up a mitsubishi dealer and they’ll tell you for free!

  • @giorgiavazishvili9309
    @giorgiavazishvili9309 6 місяців тому

    I have, colt 1.3 hatchback, on the toolbar. When I'm rolling in D mode, R is blinks and then have a vibration, can u help ? Thanks a lot

  • @realpremier
    @realpremier 7 місяців тому

    god is that a pain in the ass do remove the filler plug..

  • @turbo7283
    @turbo7283 7 місяців тому

    Dasfidania, great video!

  • @Rumrat
    @Rumrat 7 місяців тому

    Very helpful, thank you:)

  • @kazmerbakonyai9727
    @kazmerbakonyai9727 8 місяців тому

    Köszi a videót, a feltöltő cső méretét szeretném megkérdezni.

  • @rachaelboyd3494
    @rachaelboyd3494 8 місяців тому

    Is it common for these to break? I’ve had an ongoing leak repaired. All was good until yesterday. The end of the hose that goes to the thermostat housing blew off, one of the clip parts has broke off. Doesn’t seem to be held on by anything other than this little clip/prong.

  • @M1KENDO
    @M1KENDO 10 місяців тому

    Thanks it help me to change oil in my Smart 454

  • @josephnazombe4157
    @josephnazombe4157 10 місяців тому

    Hey I want to know type of gearbox oil Mitsubishi colt plus please help me

  • @thebeaver5835
    @thebeaver5835 11 місяців тому

    Nice video Is it really necessary to remove the battery to fill the gearbox with oil?

  • @gurutimes2
    @gurutimes2 Рік тому

    this is the hard way

  • @krzysztofsz.8723
    @krzysztofsz.8723 Рік тому

    The same issue in 2014 corsa d with a14xer. This small oring could cause quite big problem.

    • @marekmarecki5624
      @marekmarecki5624 11 місяців тому

      Wymieniłeś oring na nowy? Tam są dwa?

  • @Simion_T
    @Simion_T Рік тому

    My QQ-09 blower motor was making horrible noise on higher speeds. Then it completely stopped working. Took it out, disassembled it and found one of the copper bearings damaged (one towards the fan, probably due to bumpy rides and the fact that the motor is positioned horizontally). Replaced the copper bearing with one from a scrapped motor, motor fixed for free. Also the resistor unit was not working (failure of the motor bearing meant its rotor shorted with the case, resulting in overheating of the mosfet in the resistor unit). Replaced a 140°C thermal fuse inside, sourced one from a scrapped microwave owen (it must be electrically insulated from the heatsink!). A couple of hours job, saved 170 bucks if I would have bought both parts second hand, or 415€ + labor at the local Nissan dealer!!!

    • @rasmadrak
      @rasmadrak 10 місяців тому

      All hail @SimionTiberiu, King of DIY! ;)

    • @Simion_T
      @Simion_T 10 місяців тому

      You can find copper or bronze bearings/bushes in induction motors, like the ones used in floor fans.

  • @istoneyy4204
    @istoneyy4204 Рік тому

    doesnt this car need 5W30? im about to do mine thats why

  • @F142Lock
    @F142Lock Рік тому

    Wtf!!!😮😮😮

  • @robertkiraly4548
    @robertkiraly4548 Рік тому

    Vegre egy magyar video...Koszonom ....2009 es 1.3 as coltom van ...147000 merfod ..van benne ..

  • @nikij6653
    @nikij6653 Рік тому

    What the replacement part please

  • @KESYL1
    @KESYL1 Рік тому

    Hello, what torque were the screws tightened with?

  • @whatever-ku6mf
    @whatever-ku6mf Рік тому

    Any tips on fixing the lower one that is also going to the engine from behind?

  • @Filmmanufaktur
    @Filmmanufaktur 2 роки тому

    That helps me a lot! Thanks 🙂

  • @sebyy.13
    @sebyy.13 2 роки тому

    Hello man,can you can help me with some advice? I have a 2008 colt 1.3 with manual gearbox..and I can only change just to 4 and fifth gear,the first and second one ..not letting me to change, Also,the gearbox it's not doing weird crank noises like..(when you don't press completly the clutch) Sorry for bad english though

  • @David-ke2tx
    @David-ke2tx 2 роки тому

    I've just had this problem took about 3 days to realise it was actually this coolant pipe 😄. But it's all fixed now

  • @cristianocaponi7897
    @cristianocaponi7897 2 роки тому

    I changed the 2 o-rings inside it for a total cost of € 0.50 and everything was back in place.

    • @TheRossMinchevFiles
      @TheRossMinchevFiles Рік тому

      you found two o rings to replace? mine is leaking I took the clip out and pulled the hose off but only found one o ring.

    • @cristianocaponi7897
      @cristianocaponi7897 Рік тому

      @@TheRossMinchevFiles Yes, there are 2 o-rings. The first is on the flange, under the metal stop. The second is inside the plastic connection of the return (the clip) which unhooks the return pipe of the antifreeze liquid in the tray.

    • @TheRossMinchevFiles
      @TheRossMinchevFiles Рік тому

      @@cristianocaponi7897 have you a video or pictures showing the o rings?

    • @DaBawski
      @DaBawski Рік тому

      @@cristianocaponi7897 Hi, can you remember the part number or size of those o rings? Please and thank you

    • @cristianocaponi7897
      @cristianocaponi7897 Рік тому

      @@DaBawski I'm going by heart, because having many o-rings in the various bags I don't remember exactly the exact size.. it should be internal 9x1.5mm Or something there... at min. 5.25 you see the new black tube. the gasket is under the cone of the attachment with a steel stop...

  • @CosmicSoulAcademy
    @CosmicSoulAcademy 2 роки тому

    Thanks for the video. Can you please share the tools you are using? Name of the tool and / or links? thank you very much!

  • @Based-Cat88
    @Based-Cat88 2 роки тому

    Can u tell me is this a semi automatic or a normal gear box ? Would also like to know are there seal rings on drain plugs ?

  • @daisysstuff5121
    @daisysstuff5121 2 роки тому

    GOOD JOB! GOT ALL I NEED TO KNOW THANKS!

  • @cdesoysa01
    @cdesoysa01 3 роки тому

    Hi, how thick is the clear pipe for the refill? Cheers

  • @TryAndSucced
    @TryAndSucced 3 роки тому

    Thank you

  • @ilkerakin933
    @ilkerakin933 3 роки тому

    ı remove the left tire to reach the filler plug. it was kind a easier for me

  • @davidpison2243
    @davidpison2243 3 роки тому

    Can you say me the reference of the resistor for Nissan Qashqai+2 10?

  • @Osquar
    @Osquar 3 роки тому

    Doing this in 1 hour. Thanks for the help.

  • @greatunizuka
    @greatunizuka 3 роки тому

    can i have the part number?

  • @reginaldburnbridge2217
    @reginaldburnbridge2217 3 роки тому

    Hi thank you, was just looking at the changing the oil. Could you please tell me what size the filler plug. Would i get away with a half-inch wobbly drive .

  • @mateistvanhorvath1609
    @mateistvanhorvath1609 4 роки тому

    Nagyon szépen dolgozik Stefán úr! Lenne egy fűnyíróm, olajcserére, mikor vihetem?

  • @mateistvanhorvath1609
    @mateistvanhorvath1609 4 роки тому

    De szép piros szerszámkocsi.

  • @Tracks777
    @Tracks777 4 роки тому

    lovely content