Відео

all yall talking about "making oil" don't understand what this guy is talking about. this happened to me today, and buddy, that oil/gas solution shot out the dip stick tube 4 inches. time to order rebuild kit for the low pressure pump! thanks for this video dude it absolutely confirmed my issue if only you were on the river with me today, it could have saved me a heart attack 😂

Update, my 2005 F115 was doing this so I rebuilt the fuel pump and changed the thermostat and it’s fixed now, if the motor can’t get up to temp it can’t burn off the fuel correctly and will dilute your oil.

How long is the handle extension

There is a diaphragm only that can be purchase rather that the entire pump. Easy peasy to replace. Yamaha is telling customers that have an engine that 'makes oil' to run it hard for an hour to seat the rings in. Crazy info out there.

Promo`SM 😘

Okay so I have spent lots of time researching this MAKING OIL ISSUE and the primary culprit is this poorly designed fuel pump that is used on both Yamaha and Merc 4 stroke machines. (Alcohol breaks down the diaphragm of the pump and allows fuel to pass thru the diaphragm) If you have a primer bulb, pull the fuel pump off and squeeze the bulb and if fuel flows out when the pump is off the motor and away from the engine, then it is the fuel pump replace it with the cheap one from ebay or communist outfit Amazon....however if it is not the fuel pump then apparently there is a vac hose that sucks oil into the crankcase that runs thru a chamber that has oil in it can't remember exactly where it does this but it is traceable. Finally another source is the pressure regulator...that can stick and do it as well. Other reasons could be a poor break in period so rings did NOT seat before use of synthetic oils which prevent rings from seating properly...fix is to drain sythetic oil and put dino oil in and do a fast idle for a few hours to properly seat the rings...then replace with synthetic again. If the oil raises very slowly, it could be building oil because the engine does NOT get hot enough to burn it off, and that fix is a slightly hotter thermostat...this happens particularly if the motor never gets very warm...short runs etc. FYI...hope this helps.

Logan says he wants grandpa to do a landscaping one (video)😂

Go grandpa 🎉

Don't want to listen to you breath bro. And get some allergy medsfor that sniffle. Its impossible to watch😂

Some nice fish there buddy.

Your engine SN shows its a 2016. Last 2 digits show 16, thus 2016.

I like that FJ Cruiser much better than the yak, but that's because I already own an Outlaw : )

So do you have to register these kayaks, or just because you have a trolling motor? Thanks for sharing

How long has that Amazon pump last? I just ordered one from Amazon but I was on the fence still kinda am if I should put OEM back.

저도 같은 현상을 경험할 수 있을것 같아요. 많은 도움이 되었습니다. 감사합니다.

The low-pressure fuel pump for F115A is driven by the camshaft, so if anything is damaged to the pump seals or gasket it will happen like this. Just order all new seals and gaskets, replace them and you should be good to go.

Great informative video ! Thanks for broad casting .

Junk!!!

Making oil best way to notice this is happening is to fill oil just below full mark if it ever gets to full mark you know you have fuel in oil.

I also have the Outlaw 11.5 in green. I built a cart out of PVC designed like the ones in the attached videos. It is very strong, easy to use, and fun to build. ua-cam.com/video/NxKmopi1IQI/v-deo.html ua-cam.com/video/mKGVw2j6zs4/v-deo.html I designed it to fit my Outback bottom and I lengthened the axle for a lot more stability. Good luck!

My 2005 F115 is doing this, I ordered a new diaphragm to rebuild the pump, hopefully that fixes it 🤙🏼

What did you decide on as a cart? Thanks.

I was wondering if you're aware of the paddle holders on each side of the seat?

Thank you for the video. Where did you buy the new pump? Yamaha pumps cost more than $100. Thank you.

Where did you get your tiller extension. Good video

Hey Buddy nice looking kayak

One question I have been sherching for some one to explaine my why dose my Yamaha 250moter oil elevate the motet oil level do you why it is happening please

Thank you for sharing, have same problem with my engine,almost to the t.

Hey just wondering where you put your battery for the motor at!?

Halloween. Fellow can explain me the color of the oil mix with fuel???

Thanks for showing me your setup. I, too, have a Perception Outlaw 11.5, but it has not hit the water yet. It’s still a bit cold here in SW Virginia. I saw your trolling motor setup and was curious about it. My Outlaw is stock so the cutouts haven’t been made. I would have to do those before I could do such a mount. I already have a trolling motor from another boat I own. Thanks for the idea about the mounting of your Garmin and where you put your battery.

i have this kayak … i like it very much … wish the seat was more adjustable and. that the front seat mounts weren’t there but rather they designed the chair diffrently without the front mounts ….

Idling a lot and cold water idling cause this

Nice 👍🎣🎣😎

Love my outlaw I use the scupper holes in front of seat to hold rod when unhooking fish etc

Do you fish inshore? If so, how does it do in choppy water or going over waves in the intercoastal waterways caused by passing boats? Thanks.

Thanks for the vid! I have the exact same kayak in the same colour with the same motor and tiller extension arm. Love the perception outlaw!! Just wonder if you use a lithium battery for the trolling motor? Take care

U selling that engine

Pretty cool vid

I liked👍👍 and subscribed check my channel out as well

drop us an email

Cool :D