- 41
- 99 466
SweetvRevenge
United States
Приєднався 16 тра 2018
Відео
BMW 335i N54 manual (Secondary cats delete, 335is Muffler, Down pipes, Intakes, MHD Stage 1+
Переглядів 1,6 тис.3 роки тому
2007 Bmw 335i N54 manual - I have Secondary cats deleted, Downpipes, a 335is muffler, dual intakes and MHD stage 1 plus tune. I highly recommend getting a 335is muffler. It’s basically a muffler delete but very refined. I will make a video on the difference between stock muffler and the 335is mufflers from the inside too just to show y’all.
BMW 335i N54 manual (DCI, Downpipes) stock exhaust, no tune
Переглядів 40 тис.3 роки тому
BMW 335i N54 DCI and Downpipes with stock exhaust
Bakersfield Mopar gang comes to prove a point
Переглядів 1134 роки тому
Bakersfield Mopar gang comes to prove a point
Bakersfield (Mustang on Mustang Violence)
Переглядів 1974 роки тому
Bakersfield (Mustang on Mustang Violence)
My favorite picks at Bakersfield Cars n Coffee (May 2019)
Переглядів 1275 років тому
My favorite picks at Bakersfield Cars n Coffee (May 2019)
Nissan 350z Test pipes on stock exhaust
Переглядів 21 тис.5 років тому
Nissan 350z Test pipes on stock exhaust
Bakersfield runs Bmw 335i jb4 vs 2017 Mustang gt ( muffler delete)
Переглядів 595 років тому
Bakersfield runs Bmw 335i jb4 vs 2017 Mustang gt ( muffler delete)
2017 Mustang Gt Muffler delete in action Bakersfield
Переглядів 1165 років тому
2017 Mustang Gt Muffler delete in action Bakersfield
Mopar Charger squad leaving Bakersfield Cars and coffee 2019
Переглядів 2005 років тому
Mopar Charger squad leaving Bakersfield Cars and coffee 2019
Srt Jeep Grand Cherokee at Bakersfield car and coffee 2019
Переглядів 655 років тому
Srt Jeep Grand Cherokee at Bakersfield car and coffee 2019
Frazier mountain park snow day fun for family’s
Переглядів 725 років тому
Frazier mountain park snow day fun for family’s
Bakersfield car meets 2005 Mustang gt donuts
Переглядів 3,6 тис.5 років тому
Bakersfield car meets 2005 Mustang gt donuts
Bakersfield runs 2017 Mustang gt vs Hellcat srt
Переглядів 1195 років тому
Bakersfield runs 2017 Mustang gt vs Hellcat srt
Bakersfield runs V8 Lexus vs 2017 Mustang gt
Переглядів 1035 років тому
Bakersfield runs V8 Lexus vs 2017 Mustang gt
Bro how the fuck did you get the right side off? I sprayed the fuck out of it with wd40, even let it sit overnight, popped the circlip and I’ve torn my thumb to shreds trying to pull it off through the tiny gap from the bottom. How on earth did you do it? It’s the last thing I need to take off and I’ve been stuck for days now
Thanks for the video. Luckily your Torx 30 bolts were 10mm on my 2007 bmw 328xi. I used a 10mm wrench on the driver side bolt. I would recommend a ratcheting 10mm flex head wrench to save time.
Thank you
Wife’s 20 GT and my 13 370z at 70mph roll fairly even. She kills me off the line.
What’s the part number
Things pretty slow
Thanks bro this helped a lot just had mines fucked up and been tryna find vids to fix it👍🏾
I cannot get the damn higher hose connected for the life of me!! Thought I had it but it popped out a week later and drained my whole system!! Plzz help!!
This is by BC, Bako in Cali.
Sounds retarded just like every single coyote mustang. They all sound literally the same.
Can you not take the hose apart, specifically the part that connect to the expansion tank
Screaming chubacca
6:17 We've all been there🤣🤣
sounds like it ate too much taco bell
Sounds just like the turd it is😂
Thank you for this. The visual of where that hose is attached and mounted under the driverside is extremely helpful.👍
Thanks for posting! The ONE thing I came for is to find out how to get that damned third bolt off. I’ll try one of those little ratchets with a 10mm on my automatic, and if that doesn’t work I’ll start taking suspension off until I can reach it! Do you ever want to smack around the engineers that designed a specific part? 😅
that burble... how do you do that?
alot of coyotes just do when the exhaust is altered
Tap the throttle during high rpm declel with no muffler
You a real one🫡
Will this be the same as the 2011 328i xdrive n52 engine?
Pretty much except your gonna have an extra hose that connects to your transmission cooler. In the e middle. It’s gonna be a 3 way connection almost dead center.
I have the same car! I was in a hurry and found an unforgiving curb.
im gonna redownload gta and maybe we can have fun doing police chases or something.
Thank you bro!
this job sucked on thec335i. yhe reservoir side had no room
How you took it out?
@@Wizzhavingjittaking off is easy hard part is putting back on. you gotta take off what ever is blocking it
yo bro wasn’t that house tank was supposed to come with another small hose in the middle of the whole thing? you know what i mean?
*i have that hose in the middle... don't know what its for because it's connected to the same hose*
It’s for the trans mission cooler. You’re only gonna find that extra hose on cars with an N52 I believe. Don’t quote me on that. But that’s def what the other hose is for. I’ve done this job twice.
I nose my front end slightly onto a concrete garden bed kurb at home centre carpark, cracked the lower plastic part and dumped all my coolant. My new part arrived yesterday. Thanks for your video.
Man I did mines with out this video about a year ago and I was looking for this video but same thing happened to me and I thought about making a diy thanks u for saving the world
Same. Have done this twice now. lol
@@OtissSpunkmeyerlmao im back here doing it my second time too 💀
Did you have to bleed your engine to do that?
What’s sup! After installing the part and refilling your coolant reservoir, you do need to bleed it to get all the air bubbles out which is super easy to do if you look up the video But, if you meant that, if you need to drain the coolant to replace this part then no you don’t have to, but it would make it less messy if you did lol
Thanks alot man!!
The only video that I could find about this hose. THANK YOU
Appreciate it man!!
Line heater return to thermostat
do u drive it in manual mode?
😂😂😂😂😂 That’s still auto
Any idea what the part's name is? Can I find it at any auto parts store?
It’s called a coolant recovery tank hose on the FCP Euro website, but as far as auto parts stores I think they would have to special order it I don’t think they would have it in stock
I was waiting for this video Thanks
I love trumpet gang 🎉❤
Tried my best sorry if the video/ commentary is bad, hopefully this helps you guys.
mate you did very well, like you said 'you are the only person on youtube addressing this exact issue.... good job
I'm a N55 owner, and I appreciate the video. We have a similar hose that runs the same route. Unfortunately, the N55 has two plastic clips in the center section. Over time, they get brittle and break. When this happens, the hose can rub against the crank pulley. Managed to catch it before it cut through. I'll be changing mine very soon. Thanks again.
Yoo bro what did you use to remove the 2 bolts from the bracket that holds up the hose.. currently working on this right now
engine wont last long if you keep doing that on cold oil
Thanks a lot good video
I did this repair on an automatic 07 328xi and the bracket was a 10mm bolt. This video helped a lot, thanks.
How did you manage to reach that other bracket?
The hose befor the water pump part is that a clamp because autozone sells that part but I’m not sure if I’m gone need for his this whole set up all I need is that part can u help me out
@@Everybodyshinetogether1all 6 of those metal bands on my 328i automatic are a single piece of steel, slightly crimped in a factory to hold them tight. If you try to use a regular screw radiator hose clamp to replace those bands you will likely crush the plastic connector - which would put you back to buying the BMW part (not any worse off).
How did you get the right side off? In all of my mechanical days I’ve never had something this stuck before and I’ve torn my thumb to shreds
Informative, thank you for making this video!
This is probably the only video I can find on this and it's still not exactly what I was looking for. I've been trying to find a video showing the 07 n54 hose because there's a small horse shoe shaped hose we have and that's the part I'm leaking from. A shop wanted $1038 for labor and $330 for the hose, claimed it would be a 6 hr job🤡 You a 6 hr lie. Ima give you over 1,000 dollars to replace a $30 piece of rub and plastic🤣🤣 hopefully mine gets here Sat😮💨
Did you figure it out?
The dealer wanted about $2,000 to fix the oil leak on my 328i xDrive, which I thought was crazy until I saw how much of the subframe you have to remove to get the oil pan off. Planning to DIY at some point, using shortcuts from other UA-cam channels.
That’s the exact problem. One end has a circlip the other is a steel band and it’s hard as fuck to get off. There aren’t any videos on UA-cam that cover it
Hi BMW e93 328i automatic transmission, leaking on connection between coolant reservoir and this lower hose, which one should I replace?!
I would definitely do the coolant reservoir first it’s easier and also the o ring on the lower hose, before doing the entire lower hose hopefully that fixes it
@@sweetvrevenge740 thanks for answer. Do you know what is the size of that o ring?
@@sweetvrevenge740 what size is the o ring please? Mine is leaking between expansion tank and hose
@@Antonio-pq4fb I’m not sure bro I tried looking it up but couldn’t find an answer, I would try just buying a o ring kit and seeing which fits or maybe just getting one in person at the bmw dealership parts department
I found it!! 28mm OD 20mm ID 4mm CS Mine is fixed now
Ur shifts take 1-3 business days
sounds terrible, stock way better. sounds like a can with rocks in it. looking great tho
Tyre writing is so tacky, a shit modification.
I may be getting a 350z soon idk yet I hope tho
bruh just get a MHD adapter and download a tune, my 100% stock motor with stage 1 would be way quicker than that ... just get the tune dude
El Poder Méxicano Ford Mustang Nunca se Raja.💯🥵💪🏻💪🏻💪🏻💪🏻👏🏻👏🏻👏🏻
Es Américo wei ?
@@way2comfortable698 simón me Equivoque es Americano asi el Maverick es Méxicano 👌🏻👍🏻🔥💪🏻
Needs a tune my stage 1 is quicker than this.
What’s up bro , I’m looking into getting downpipes with everything else stock besides intakes with no tune how has your car felt? How did you get rid of the check engine light ?
Tune it don’t be a pussy no other way to get no check engine light
What sup bro and that’s exactly what I had in this video and the car felt good with no issues, I would recommend just tuning it on mhd though but I don’t think it super necessary right away, as for the check engine only way to get rid of it would be by mhd or getting o2 spacers