Відео

Too fast..camera moving too much

can you end the video....

Thanks man for this video upload it help me a lot 👍

How was it running before this tho ? My fuel pump went out and now my truck is running super ruff and stalls out after running for a few seconds. Please help.

Thanks bro

How did you figure out how to do this, like what was your steps in figuring this out

Did this fix the issue?

So where did you find a replacement?

I'm seeing two different locations on UA-cam for a crankshaft position sensor.. here and the rest right above the starter. Mine is a 2012 malibu. Thanks

🫡🫡

Love how the music's so loud. Can't hear what the fuck you're saying

The ground is on the bottom driver side of the block .🤟🏿 Follow the battery ground down .

Mine did that i just cut all the original grounds on that stud under cylinder one and ran them all up there where you did. It was a pain in the a** to get to lol. Now that there up there i aint gotta worry about it again, lol.

Thank you

Can I do this on a 2017?

Did you cut the wire or just tied into it

What is the blue thing you’re running the black wire to?

I just did this and I’m just letting everyone else know this is a pain in the ass

Terrible video! Audio faded completely away. not professional mechanic procedure. You're probably a good mechanic but the video doesn't show it.

Why didn't you just check the grounds underneath cylinder 1? It's the ground for the ignition coils.

How much will this cost including labor

Was the coils not producing spark because of the faulty ground?

Trq makes a compatible alternative for it.. cheap.

My fans don’t turn on what to do

If you remove the air cleaner box the front of the battery box slides up like a trap door and the battery will slide forward.

Good video. Too bad I was already finished when I found it. Did it the same way but you would have saved me time for sure.

Thanks helped by now my spring ceased I think I'm screwed my belt won't go back tight and I don't even think they make that part

I tried it connected to the black wire as explained and now It won’t even try to crank. Any pointers?

So this was just a removal explanation video…

did you remove the oil pressure sensor 1st or just the connector to the oil pressure sensor? i have a 2004 malibu 2.2 l , 4 cyl engine the plastic intake manifold is too close to the oil pressure sensor connector and i was unsure how to remove the connector from the oil pressure sensor. also my crank sensor is held in by a 10mm bolt not 8 mm. any ideas appreciated, i am assuming you did not have to remove the starter. my oil filter housing is the same as yours.

Thank you for this video. I had the exact same problem and I fixed it doing what you did. You saved me from spending thousands of dollars or junking the truck. Thank you taking the time to post the video.

Thank YOU. IVE got one scheduled this morning.

Thanks, just what I was looking for

Thanks for the vid. Simple and to the point

What was it doing at first ??

The best video on the internet, like Galloway said a 2 min vedio gave you all the info needed.

Quick easy thanks bro

Just wanted to say great video

My man 💪 thanks for not sharing your life story great 👍 video 👏

Badass. Straight to the point. 💯

Good job sir.

That 24mm was to remove the sensor right?

Keep up the good work I'm working on 1 now and it was a challenge but I think moving that strud to put it back in will help alot thanx for sharing knowledge 💪

Brother why not put the part number if is more help thank

Works in 2022

man that was quick. wish you would have recorded it

Thank you!!

great tip on removing that torque arm...

That bracket thru volt was so tight I couldn't believe it. That was the hardest part for me. Good video

thank you man im out here tryin to do this on my wifes car right now and its 25 degrees out