Відео

No. Xentry is not needed. From my exper. if all the sensors start working, the lights should go off the dash after you begin to drive.

what do you mean "witch"?

@@mercedes-benz2127 це дуже кумедно - людина, яка гребеться в ксентри питае а що це таке Ведиамо? )))

@@Ramis.Djabarov Vediamo? Yes, of course I have Vediamo & DTS Monaco too.

Well. I don't think this experiment affects the hybrid system.

at 41:44 - are the connectors for the cameras to the 360 control unit, red/blue - mirrors, yellow - rear camera, black - front camera... as you see at 42:20, I insert black into the black - front camera connection

@@mercedes-benz2127 you used the 360 module, yes? I believe my android radio being that it has 4 inputs for video can be used as the module. The only issue I have is how to figure out how to get the front camera to trigger the video to show on the screw when the car is driving. The side mirror views will be triggered by the direct lights on the mirrors light yours.

@@clabruno I think you need to look at your screen manual. If it has input for the 360 cameras than you need to see what cameras it is compatible with. And then also you need to search the manuals on where to configure the bringing camera videos on the screen. What screen is that? My 360 camera does not have any trigger for the front camera. If I want to display it, I have to use the remove control to switch the 360 unit on and it will come on the screen.

I believe from what I read the front camera might come on with my radio at low speeds. I will check n let you know

No, haven't lost it. The rear camera from the kit has the light built in, and it works, but gives a bit less light than the left one.

I did not connect it to anywhere. It's a trigger cable for the external monitor if you have it. Have a look at the following page that sells very similar camera system. www.aliexpress.com/item/1005005489763655.html?spm=a2g0o.productlist.main.37.46ff2cc0azsWxM&algo_pvid=9906d72e-865f-492d-85f2-6f1e39573af0&algo_exp_id=9906d72e-865f-492d-85f2-6f1e39573af0-18&pdp_npi=4%40dis%21GBP%21213.11%21213.11%21%21%21267.02%21267.02%21%40211b82c017207843660287995e5062%2112000035945866652%21sea%21UK%212521224462%21&curPageLogUid=jhimC2KZlGjJ&utparam-url=scene%3Asearch%7Cquery_from%3A

couldn't find mosfets with common ground, most of the boards on sale have common positive, so I would have to run separate ground wires everywhere

Not sure. You better ask the seller. They should know if it works with your model. Sorry. thank you.

Yes, it would be the same. I would say for all Mercedes diesels. I would also include: checking the brake liquid for the water level (in %) and checking/tightening of the valve/rocker cover - 16 screws, 9nm torque, in every service. I recently spotted some oil leaks from under that cover, and when I checked none of the 16 screws was tight enough, had maybe 1nm of 0nm :) ... So now I recheck that at every service as well. here is the video about E250, looks the same: ua-cam.com/video/FhtOh4Uq67I/v-deo.htmlsi=jZRvqIYAA6BK-AgF

I do the staff described in this video during almost every service, and the ash content that my MB Star or ThinkDiag show, remains under 1g. As you can see in my latest video (at the 21st minute) : ua-cam.com/video/zJYiA1GzW58/v-deo.html

@@mercedes-benz2127 how much did u pay for the dpf cleaner? And how many cans did u use? Thanks

@@kharali3475 it costs about 10gbp, usage 1 can. www.ebay.co.uk/sch/i.html?_from=R40&_trksid=p2334524.m570.l1313&_nkw=motip+dpi+cleaner&_sacat=0&LH_TitleDesc=0&_odkw=motip+dpi&_osacat=0

@@mercedes-benz2127 thanks, just purchased 2 cans as it worked out cheaper £15.99. Will try it next week

Tried one can today, put through the dpf pressure sensor hose, soot levels and ash still the same after driving for about a hour. Are you suppose to do a regen when you use this? Thanks

Hi. Thank you for the comment. The kit I bought is this: www.aliexpress.com/item/4001236869080.html?spm=a2g0o.order_list.order_list_main.145.21f21802BLcVof It now shoes much cheaper than I bought it. Also not sure about the module name. This was 2.5 year ago, and it was a cheap Chinese 360 camera kit. It works OK now as well. The only thing I had to do since then is to replace the rear camera. What I don't like about it is that it has a wide view which I don't like. I would prefer linear rather than wide. Also, I cannot make the lines work. I mean the ones that show the live path or guide lines where your wheels would go. You are talking about some radar. What do you mean? Is your rear camera does not show when you put into reverse gear? Or something else.

@@mercedes-benz2127 on screen of display, on 12,5" android, i have a picture of the car and signs like spider web (radar lines). It doesnt mater what camera i connect, that image is fixed on the reverse screen. Can i deactivate that somewhere in setings of android unit or it is there because of the sistem instaled?

@@djovidius3545 On the screen, when you go to the settings (the very right one), then Reverse, then you have to choose 360 Panoramic Reverse CVBS. You can also try the different options and see if it works. The very top one - Original Reverse is for the vehicle original reverse camera (if you have one installed).

@@djovidius3545 Here is the link to the picture just taken that shows what I mean. Have a look. I cannot post it here, only the link. drive.google.com/file/d/1BD3pKqR-emnet6O8njmL0nc5FwASOGX5/view?usp=sharing

@@mercedes-benz2127 i will try to explpde the sistem, to find those settings. Thank you.

No. No coding needed.

thank you

@@mercedes-benz2127 can you please say what 360 camera kit you have? what module, name? i bought something that is different and pain in the a$$. how that in reverse you dont have that radar image from the stereo unit? i havve similar and i cand take it off or deactivate it.

So far my bambino has done 310K km (or 195K m). No issues. The hybrid battery last time was checked with MB Star a month ago and all cells are in order. The 12V battery is still original. It's OK and starts the car without issues, but you cannot sit with it and watch a movie for longer than half an hour without running the engine (or starting the car, which will use the hybrid bat. to change the 12V bat till 34%). In Sep. 2019 I replaced the starter. The old was OK, but MB Star said it was more than 300K starts and it had to be replaced, and I didn't want one day to get stuck somewhere on top of something like Timmelsjoch (Italian-Austrian Alps) with car not starting :) . Replacement took whole day, but the new starter has been working well since then. I didn't record a move during the replacement, but took some pictures, and will probably make some video with pictures and comments. All the services requested by the car are done in time and as requested. My services span around 15K miles (25K km) because most of the time I drive like old woman - usually not faster than 100 km/h (60 mph). The oil that I always put, always says ACEA C3 (low ash) - this very import. for dpf. And also, every service I apply the dpf ash remover as in one of the videos on this channel.

Thanks for the comment. This is Birchington near Margate, Kent. I cannot really advise any camera. I did this video while installing the camera I bought at that time. You need to look around because it's been 3 years since then and these thing change and get updated every few month. If you could find the stock 360 camera system that would be the best. But I think it's just very expensive. This camera system works well, but the problem it has is that it shows wide view, but I would prefer the linear image, that is not distorted, like the standard rear view camera from Mercedes.

The tool and the app is ThinkDiag. it's about 40 GBP per year per single car and yes, it is bluetooth. thank you

@@mercedes-benz2127 ThinkDiag on the W213 dont work.

Hi. Yes, if you attach a cam that is recognisible by this Android, it can record. But it would be consuming resources, and thus slowing down the operating system. So I would better have a separate dash cam. That's what I think. I never tried to use this system for live camera recordings. It has two usb (usb-A) slots and microSD and microSIM slots as well.

Not sure about that. When you'll be buying the camera, just check the compatibility. They should always tell you if it would fit your model. Speaking of the indicators, I think it can be done as they do them for basically all models. But one always has to check to make sure it fits.

- Yes, it is possible to get full eng. + electric power if you hit the pedal hard enough; - It can pull on electric only but if you press the pedal very slowly, but under normal driving, like pulling away on a traffic lights, no, the el. motor power (20KW, 26 bhp) is simply not enough for this car, and if you want something like that you need plugin hybrid, like 300 de model. - no, I don't know if anyone tried to chip this engine, - detling hill is perhaps the only place in south-east, where you can get some 95% charge (~80% internaly), 100% charge was happening only in Alps :)

La interfaz es el módulo de control que vino junto con las cámaras.

I thinks this should not be a problem.

You have to scroll right or left to services and then coolant temp.

Yes, that is sometimes the case. Also, make sure your eng. oil is low ash. That would keep you out of the trouble. Thus, when buying eng. oil, make sure it says ACEA C3, not less than C3, like petronas 5w30, where on the can clearly states ACEA C3. ACEA A, B all have higher ash content. C3 is the lowest. They also make 0w20 that is C5, but I have not tried it yet. It would definitely. be good for winter, but if you do oil change once a year, than you need good oil for summer as well :)

@@mercedes-benz2127 thank you :)

Same codes for me. Did you solve replacing the sensor?

@@ticktime6569 yes the new sensor fixed it. Make sure you buy a genuine Mercedes one for peace of mind and ease of troubleshooting

@@K20TypeR thank you very much :-)

12:23 - shows installation inside the mirrors. When I bought the camera kit, it came with the bottom housing for the mirrors that had cameras already in them. So you just replace the whole bottom part.

@@mercedes-benz2127 Thanks!

Sorry for the late reply. The Mercedes pn is: A6429050100

you dont understand how ash calculation works! Car dont know about ash anything it just uses formula to calculate theoretical amount based on km driven and regenrations.. most important parameter is diff pressure yours is 70mBar @ 1500rpm. Hard to tell what have to be in your car while driving, but at idle it should be ~2mbar -less is better

@@SayWhaaaaaaaaaaaaaaaaaaaaaaat Dpf still max 10 mbar at idlle is ok.

Sorry for the late reply. The calibration markings are shown from 47:05 . Basically you draw the 4 lines that are parallel to the sides of the car. Then you draw 4 boxes on each corner of the car. Boxes are 1 meter long and wide. Then you sit in the car and move the calibration points onto the corner of each box.

Not sure. This was bought from aliexpress. Here is the search results on that site: www.aliexpress.com/wholesale?catId=0&initiative_id=SB_20210427215716&SearchText=360+degree+bird+view+camera+for+benz

the bluetooth settings are in the network menu and also in the system menu. I used them for sound, for Insta360, and for other connection. Did not have any problems so far.

About Torque: You go to google play and download the Torque. Then connect the device. Start Torque and it should find the device. If it does not find it, than in Torque you go to settings and choose the device that you have. If Torque cannot find the device that means that this screen's android system does not recognise the bluetooth device.

about the clips: ua-cam.com/video/aGy95ir3BtE/v-deo.html

Thank you.

Not really that ugly. Yes, the stock system would be better. But if you don't have it, but you need 360 view than this option is not that bad. If you want to install aftermarket original from Merc than it would be fairly expensive. Consider that only one camera is $700 second hand, and you need 4, and then the control unit.