Відео

My wife and I were at this show Rockford Illinois What a great show

I would use loctite...or get rid of it if it gives you that much grief.

Name me ONE artist today that can do what 70+ year old Halford can do for this long. They don’t exist Halford was just made different.

Mines the exact opposite. 2001 Cherokee. Switch replaced a year ago and it just happened again. I wiggled around by the blinker switch and it came back on for some days. Back off now. I’m loosing my mind.

Dont want to loctite screws that keep coming loose but yet you rather scratch the gun all to hell lmfao I'll give you 50 Bucks for it since clearly you was born feet first

Hell yeah, good job. Gonna do the same thing to one of mine here in Wisconsin.

The beginning is rear brakes. 14:06 is where I begin the frame repair. 16:45 my most important tidbit to share. 29:25 23 gallon fuel tank swap.

What is the point of this video. You leaked your own address and then like a child you destroy the “tough Chinese crap” that you bought. You don’t just receive fake electronics in the mail.

Loctite is useless on my jm. I shoot with a screw driver in my left hand Seriously.

Bruh, fake AirPods

Does it work?

ahh, the best pros i have aver seen

Those are 200% fakes. Glad you destroyed them, probably 2$ to manufacture the fakes

Expensive?? As a Mexican I thought those are or will be the most common earbuds I even got a pair

bro js leaked his addy😂

Fender sells brass washers specifically for that issue.

😂🤣😆😭😜

Voice coil rub is when the coil rubs against the magnet. A bent gasket impeding the speaker to sit flush is another issue.

Thanks because I was about to use bricks on my challenger replace drive shaft with the same setup.. now I'm getting 2 more ramps so it can't move or I'm thinking jacking each end up and putting the little stand so that the car is jacked and level with tires for extra support if them Jack's fail... what about 4 ramps and jack each tire up then put a ramp under the tire so all 4 on ramps and little stands for support ...thanks for the safety tip

Thanks for your video, maybe try blue loctite to see if it helps 👍

Good looking out

Thank you for this video! I want to make a stronger one, with a single neodymium magnet and bigger copper coil. Can I wind the wire directly on the magnet, with only borders on the side? Or do I need to prevent contact with the magnet with a plastic spool or something?

So, why not loctite?

Not sure what you were going for here. I use a 65 Twin Reverb reissue without modifications and it sounds just right with my 9-string. Don’t need to crank it to the max anyway as I want clean headroom, and then the peals do the job. No Behs tho.

Sold! Wait... did I work on this already?

hi, great VID; can you tell me asap you said r``ad lines snap in`` ; I HAVE A CAR DOWN AND NEED TO PUT THE AZone rad in asap; 'cant affor to break cooling lines:: are they like fuel lines? screwed in? special tool ?? WHAT am I getting into ?

was the grout mixed properly??

OMG, I already noticed a spelling mistake three minutes in... If you're jeep is acting funny or just quits and/or won't start, it's likely these capacitors that have failed. This is the third ECM I have rebuilt. 19:13 is where I show you how to properly use the desoldering wick. The kit was purchased from diy-electronic-store on eBay. You can do this!

WOW!!

Thank you. I will give it a go👍

FERNANDES Sustainers or SUSTAINIAC do not remotely cost 1000 dollars. fun project, but youre needlessly destroying that guitar. Veyz makes a great sustainer custom to your specs for about 150.

Guys on here complaining, and then said don’t tell me a solution… Loctite would fix all your issues and doesn’t have any disadvantages.

Dang! I was thinking about doing something similar but I was really worried about managing the heat, I have a TSL602 and I hear they have a reputation for Seppuku'ing themselves Its been 3 years for you how they been holding up?

Did you buy these off of amazon?

0:55 bhahahaha

You always get the whole car off the ground if you are working under it and never work on an incline on tire ramps! 😵‍💫😵‍💫😵‍💫

I'm about to work on my 300 front left CV axle and now I'm curious if the parking brake will hold the car in place if the rear wheels are on the ground?

So glad you made this video. I have the same issue right now but with the rear shaft disconnected. It's an AWD that the rear shaft came apart on and PARK won't hold it in place. That AWD transfer case must be like an open diff spider gear.

Do you know how many ohms this amp runs at? Wondering if I can use this as a cabinet for my 50W Marshall 1987x

Do you have to get a new distributor or can you just lube it?

Pretty cool hack! Im pretty sure that its been noted by Two Notes that Captor cant drive any headphones output , youd have to get a separate headphone amp for that , or the Captor X

Wrong stock, wrong screwdriver, you sir may own a lot of guns but you don’t know anything about guns

I’m sorry sorry this happened to you 🥹

How? Why?

Terrible advise…

My dad owned a kabar 1189 and ive restored it decently when it comes to eust and the handle, but its missing a lock pin, do you have any idea if i could fix it in any way or buy a new lock pin?

Um bloqueio de grade muito leve torna o timbre acrilico percebi que minha modificação no tiny terror no acoplamento v1a v1b 1nf para 22nf tipico de vox ac esta turbulento expelindo tornados pelo duto do gabinete o falante esta distorcendo com os graves

Pshhh, this is nothing. When I was his age I was bowling over 500. EASY. just kidding..this is impressive. Very well done.

I have a iPhone 13 fully updated to the newest iOS version, I dropped it I use it 10 hours a day, I take pictures and videos all the time. Even my old iPhone 11 still works flawlessly and it has more wear and tear. It’s not apples fault it’s the owners fault. Also if you have this mindset that all tech giants make crap tech so you can buy more then don’t buy it. In fact 0:14 apple keeps updating phones 7 years after their release dates while other major brands only support 3-5 years. And maybe you just need to clean your phone and take care of it better. I work with my phone for hours a day but I can still take a few seconds to make sure that it won’t get damaged. If something doesn’t work right for you then before you blame it on the company think if you could have done a better job taking care of it.

Take a look at Pixel