- 163
- 303 566
SRTKHRIS
Приєднався 21 лип 2011
Відео
Challenger Overhead Console Install For Panoramic Roof
Переглядів 16Місяць тому
Challenger Overhead Console Install For Panoramic Roof
Direct Connection Tuner For Hellcat Swap
Переглядів 66Місяць тому
Direct Connection Tuner For Hellcat Swap
Dodge Challenger Panoramic Sunroof Installation
Переглядів 3433 місяці тому
Dodge Challenger Panoramic Sunroof Installation
Dodge Challenger Panoramic Sunroof Install part 8
Переглядів 1434 місяці тому
Dodge Challenger Panoramic Sunroof Install part 8
Dodge Challenger Panoramic Roof Installation Part 7
Переглядів 654 місяці тому
Dodge Challenger Panoramic Roof Installation Part 7
Dodge Challenger Tail Lamp Lettering Removal
Переглядів 205 місяців тому
Dodge Challenger Tail Lamp Lettering Removal
Dodge Challenger Tail Lamp Lettering Removal
Переглядів 95 місяців тому
Dodge Challenger Tail Lamp Lettering Removal
Challenger Panoramic Sunroof Installation 6
Переглядів 1525 місяців тому
Challenger Panoramic Sunroof Installation 6
Challenger Panormaic Sunroof Installation 5
Переглядів 885 місяців тому
Challenger Panormaic Sunroof Installation 5
Challenger Panoramic Sunroof Installation 4
Переглядів 465 місяців тому
Challenger Panoramic Sunroof Installation 4
Challenger Panoramic Roof Installation 3
Переглядів 465 місяців тому
Challenger Panoramic Roof Installation 3
Challenger Panoramic Roof Installation 2
Переглядів 435 місяців тому
Challenger Panoramic Roof Installation 2
Chrysler 300 Panoramic Sunroof In a Dodge Challenger
Переглядів 6165 місяців тому
Chrysler 300 Panoramic Sunroof In a Dodge Challenger
DS18 Sound System with HY6.4B HY8.4B & DS18 SLC-8S
Переглядів 1,1 тис.Рік тому
DS18 Sound System with HY6.4B HY8.4B & DS18 SLC-8S
Watchu touch some wires together 16:52?😂😂
Can you show me the resistor you had used and how you wired them
What is this for, or what does it do?
Tune
Diablo is old news hp tuners is where it’s at
You're right I have both but I like the convenience of taking the smaller diablo with me compared to taking my laptop they both have their advantages.
Yea I feel ya I wish hp tuners had the Diablo setup would be dope
@SrtHemiPower yeah that would id definitely get it 😂
i gotta 2016 sxt charger swapping to a 5.7 is it possible for me to drive on the stock drive train for a while until i get the new one. I won’t push the car too much
No you'd have to change the transmission and driveshaft along with the exhaust at minimum.
👍
😎
Thanks for posting, not many reviews for this so your video is welcomed.
😎
What wire harness did you use to make them work. I have a 2009 as well with 16 model headlights
I purchased the 2015+ pigtails from eBay for $25 I'll send the link
Im doing a 5.7 hellcat blower install was the company that did the computer unlock and install the base tune any good.
I got it done in North Carolina for $99 I just sent it to them and it was back in less than 10 days stagefp.com/product/chrysler-pcm-unlock-2015-2020/
I don’t understand. How do you do the center tail lamp when the original is backup, park, ground and the modern is right rear side marker, left backup, ground, right backup???
I can in ixc you with the step by step if you want
How did you wire the center one? It seems like there is too many to splice
For the backup lamp do you do two to the same one?
That’s next level right there
Yeah once you get a panoramic you can't go back 😂
yo i have a 3.5 and tryna v8 swap any advice ? was it a difficult job 2 find places for everything?
It's super easy almost plug and play when you get the parts from your same year. If you have a pull a part location near you that's the easiest cheapest way to do it you'd save big💲
How’s it going. Did you leave the stock Hellcat pully? Did you have to make any adjustments so they could line up with the 5.7 pullies? What timing cover did you swap it with? Thanks
Yeah I like the stock pulley I pretty much did the hellcat timing cover, oil pan, and water pump along with the stock pulleys so I didn't use any of the 5.7 pulleys with the setup.
Do you still have that supercharged 5.7 I was wondering if you could put two front mounted turbo on it and make it pro charged
No I just have the hellcat swapped challenger and another challenger I'll be doing a hellcat swap on. The hellcat supercharger 5.7 is down due to blower damage it's back with its owner I think he wants to do a hellcat swap now
(Asking because I also plan to do this myself) would you be able to mount 2 front mounted turbos on this as well?
No it has to be one or the other but to be honest the Magnuson or Whipple route is the best way to go...alot of these hellcat supercharged 5.7s aren't being tuned properly so finding the right tuner is key
@@SRTKHRIS Not saying you’re wrong, but why is it either one or the other? Is it just too much boost?
@@Ldot260 it's mainly because the level of tuning needed for it to work properly doesn't exist yet 😂 I've seen alot stuggle with hellcat superchargers on 5.7s so adding a turbo to the equation would have most tuners dumbfounded 🤣 so I wouldn't recommend twin charging but if you have the time and the patience go for it I'm sure itl be alot if trial and error..possibly a blown engine or two..or three 😂
I have in backside same tweeter Pioneer + midlle Sony + sub MB Quart. Pioneer is best if not enoght high freq. My Lincoln Navigator 99 sound is crystal balanced in backside. Front have 3way Kicker + rockvill twitter
That boi burning 🔥
Don't listen to the haters. Doing some proper old school work right there. Gonna have a very unique ride by the end of it.
Facts facts it's basically done now minus the electronics 😁
were you able to get a key programmed with no problem?
Yeah I have my own key programmers I hate calling locksmiths or going to the dealer 😂
Put a kill switch on it. Would hate to see all that hard work get stolen.
I want too see the roof finished
I'll start posting videos soon I'm looking for another harness to get the roof electronics working.
I gotta know more about this sunroof. Hope you do full video.
Yeah full video coming soon 😎
@@SRTKHRIS can’t wait!
How much
$307 for the engine $55 for the rear cradle $65 for the differential $45 for the two rear bilstein shocks
@@SRTKHRIS damn was it running I’m in htx tryna a motor for my 300 them junkyards want 1500+
Can I do this on my Chrysler 300 6.4?
Id go with the Magnuson the work is easy but finding the right tuner is the real challenge which is why I got away from doing the hellcat supercharger swaps 💯
Not sure what's worse. A hack job with a shitty running motor. Or putting it out on the internet for everyone to see. 😂
P r o m o s m 💘
Looks like an RT with them skinny a$$ tires. RT’s are good for racing Honda 4 bangers, and they still struggle with them. 😂
👀
did u have to change your headlight support on the 2009 to put the 2016 bumper on?
No thats the same from 2008 up 😎
That spin out cost him madly 😂
😂 💯
Update? How's it working for running tweeters?
Works great I'll do a video soon I want to buy more for my other car 😂
No supercharger coolant revisor?
No just an inline filler...the size of the heat exchanger triples the fluid capacity compared to stock capacities
I did the swap as well on my 2010 with 2015 light conversion front and back no trouble at all swapping rear bumper and light and wiring them up but the front light I get the turn signal but wen tappin for the low beam there super low to where wen I turn off the garage light they barely light up…. Can u help me but pointing me in the right direction maybe I’m not tappithe rite wires is possible u can send me ur wiring diagram so I can compare notes
I used the wiring diagrams from the Mopar factory service repair manuals. What size are the resistors you're using?
Is the fuel line setup the same on the Gen3 6.4 and 5.7?
Yeah same setup it's only slightly different on 2014 and under models
what’s ur email bro? i got questions.
georgiapeachesiluv@yahoo.com
Can these be wired to 8 ohms?
I wouldn't do that it would definitely shorten the life and cause more distortion 💯
@@SRTKHRIS thanks. My old lexus uses a factory Amp that runs 8ohms
@@ClearWater7.62 ok cool can't go wrong with a rockford fosgate lol
I need this done on my car
Yeah it's a good setup with the right tuner..I'd only trust 2 at this point 😂
Yo I been trying to swap my 2020 sxt chally to 5.7 I got cpu 3.09 differential and engine and trans what else would I need and need to do ?
PCM, complete exhaust, driveshaft, engine harness, you have to get your used pcm's vin changed to your current vin, I'd go with some brembos too while youre at it 😂
How did you get your high beam headlights
I've been meaning to do a video on the wiring in detail but it all matches up there's two different ways you can go about wiring it. Did you already purchase these pigtails? www.ebay.com/itm/374813998325?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=iqbi9jinrw6&sssrc=4429486&ssuid=Cw9Oi3-vSIy&var=&widget_ver=artemis&media=COPY
So I got a 2017 sxt and got a 5.7 engine w the tranny what else do I need to
PCM, complete exhaust, driveshaft, engine harness, you have to get your used pcm's vin changed to your current vin, I'd go with some brembos too while youre at it 😂
@@SRTKHRIS what about the bcm and tcm
@@recklezzreacts4062 you can keep the same bcm and the tcm is inside of the transmission on 2015+ cars
@@SRTKHRIS last question the pcm can be off any 5.7 2015 and up right and thank you to for the replies gang
@@recklezzreacts4062 it can but it's easier to match the same year because when the year is different some of the PCM pins change locations so some functions may or may not work.
How much horsepower gain with the5.7 withe the hellcat supercharger?
Hemi purple did a Dyno at over 600 horsepower to the wheel but to be honest after you add the money up it comes real close to a used hellcat swap 😂 that's why I got away from doing those. Also having the wrong tuner can be a disaster with a hellcat swap you'll have more power without relying on a tuner who may or may not dial it in properly
@@SRTKHRIS thanks brother 🫡
@@boobizzy863 no problem I might be doing another one this summer on the 300
@@SRTKHRIS make sure you record the process bruh 🫡
@@SRTKHRIS what city you in?
This is to swap out the wiring that connects to the outter taillights on a older model to a newer model?…I noticed the sidings were off on my 2013 challenger when I tried to put the newer model taillights on
Yeah this diagram helps you wire everything in. Yeah itl be off unless you get the 2015+ rear number
what issues was you having due to the bad oil pump?
I had the check engine light come on for low oil pressure. Ran a data log and saw the low psi at idle only.
I had the check engine light come on for low oil pressure. Ran a data log and saw the low psi at idle only.
mines oil psi will go as low as 16
Yeah I'd definitely change to the melling oil pump
@@SRTKHRIS ok thank you cause I'm having issues like when I hit the gas car does a noise dive and no gas power for like 2 3 seconds
what sensors did you not have connected ?
I literally hooked up the harness to the pcm, cam & crank, injectors, and coils then started it. Ive always done this just in case I have to address any internal engine issues before continuing
@@SRTKHRISso for v6 to a 5.7 it’s a plug and play when it comes to harness
how did you wire your high beams can't get mine to work?
Are you using aftermarket bulbs? I know some aftermarket bulbs don't work with the high beam. I can also send you the wiring diagram if you need it.
@@SRTKHRISI’m using the bulbs that came with the lights ! please send me the diagram everything works but high beams ! Thanks
@@eguag12lmk if u get it
Also do you still have that challenger u swapped out?
Yeah I still have it but they doubled my insurance on it 😫 so I only drive it in the summer.
Yo Bro i kno im years late but I have a question or 2 if u could answer back 🙏🏽. Im looking into swapping my 3.6 2012 SE charger to a 5.7 I have a co worker willing To sell me one out of a 2013 Durango for $500 134k miles BUT he doesn’t have the wiring harness. I see a few online for $250 + but they are different years does that matter or I need it to be a 2013?
Yeah 2011-2014 you're good to go
The PCM should be from your same year as your charger to make it easier
@@SRTKHRIS thanks bro I really appreciate you!
@@SRTKHRIS thanks bro I really appreciate you!
Bro i kno im years late but I have a question or 2 if u could answer back 🙏🏽. Im looking into swapping my 3.6 2012 SE charger to a 5.7 I have a co worker willing To sell me one out of a 2013 Durango for $500 134k miles BUT he doesn’t have the wiring harness. I see a few online for $250 + but they are different years does that matter or I need it to be a 2013?
That's a good deal 😎
That 5.7 sounds like it has been better days 😂 pretty sick though but definitely needs a tune up lol
Lol that was initial start up the first day I started it with no sensors just to see what I was working with 😂