Відео

Any idea why my raptor 660 coughs and sputters and won't even move when I put it in reverse but it runs and drives perfect in all the The forward gears

Hey I have a question what are the jets sizes ??

Hey I just rebuilt a raptor 660r 01 including the carbs , I changed the compression to 11:1 with a high compression piston an the set carb to manual specifications and when I start it i can't get it too accelerate it just sputters , any suggestions?

“I’m white I can’t shoot” racist ass😂😂😂

Insane job!! Question please my raptor 660 2001 Does not whant to idle!! Have to hold trottle And the jets they mixed them up where i tryed to get it fix!!!!😢 Thanks

Mine idles fine but won’t take throttle. It stumbles and backfires when you throttle. It came without a plate over the throttle on carb and no air filter.. I installed both

That is great info. I’ve been having problems with these new carburetors I put on mine. I don’t think the air and the fuel is set, right

How many turns have in the air

Throw that shit in tha trash🚮😂

what if I have black smoke coming out the exhaust??? what would cause that and what would be the fix??

I am having trouble getting my raptor 660 to start I got hosed buying it on Craigslist so I replace the whole top end and everything else including wiring except the gears in crankcase it started first shot but after I turned it off it won’t start again any ideas

Okay so I had my ATV shipped in parts to where I am now (Pakistan) it’s a euro model. Since putting it back together I’ve had a few issues (I’ve gone by the manual guidebook. . Carb problem. I cleaned the filter out and doused it with engine oil to make it stick and I blowed and pumped air through the carb on taking the air filter out and little little bits of silver would come out and be visible in the petrol. Didn’t work! Overflow pipes are throwing out alot of fuel and to basically stop that and prevent it I’m having to leave the fuel on half or less than half on like literally a little up from off. Now I need to open up the carb and clean it n check the float levels. Can anybody guide me or give me any advice as where I am now there isn’t a mechanic or anyone who specialises in these machines so I’m gonna have to go about it myself. . I have a tooth on the front sprocket broken, which I think may have something to do with the bike not going in neural when switched on. My question is if I were to get it repaired as it’s only 1 tooth on the cog would it be okay or would it be best to replace the part as a whole (remember I’m in Pakistan there’s no part market for this and will be a long wait in the post) so could it be possible to repair that sprocket cog. The bike does go in neutral but only when switched off does not happen when started. . Choke problem. The chokes basically still too high or fast even at the lowest point as in the bike still warms up even when it doesn’t need to and then gradually heats to a point where the bike turns off and the cooling fan comes on. . Any help would be very much appreciated! Thanks for reading, i will take pictures and upload in where I could get any assistance. .

Mine starts to spudder and end up dying only wen I’m on the gas hard any ideas

Good afternoon I have a 2005 660 raptor I cannot get a spark , get just click click when trying to start any suggestions

I have a raptor 660 2003, I just can not get the carb to work. If it send it too you can you rebuild it and how much?

Y are you moving the phone around

Thanks for sharing this I'm rebuilding mine now

I installed a bbk cable and now my clutch won’t disengage wtf do I do? I got a fire wall adjuster and a aftermarket quadrant but the cable ain’t pulling the fork far enough to disengage ☹️

Got a 660 kepp back fireing put new carbs on back fires a little bit

what model of mustang is it?

Hey did you put your carbs on there's sides and so the float tab just rests on the needle valve tip and measure?

Have a raptor 660, I touch the throttle and it sputter horribly, I got further and it back fires

HELP!!! I have a 2003 Yamaha 660R Raptor that I just took for a ride down the road with my son nice and easy we'll say and when I pulled up to the garage when done my airbox was full of oil which leaked out the bottom of the airbox everywhere do you know by chance why it did this? I am at a loss?

This man knows

any chance you know the size of the washers? My quadrant didn't come with any

I have a questions about a 01 Raptor 660, the float leaks fuel and when i start it the idle is really high then dies like it's running lean. What should I do?

So did you put spacer behind quadrant?it don't look like you have one on the arm. If not has it given any trouble? Ex: broken cable

Hey my raptor 660r is over heats when cruising on the trials with my kids but if I gun it. It will not over heat. I'm using dynojet 144 for the low and 146 for the high. For the needles it's at number 4.

Hey man I’ve got my carbs set on 3 turns on both it cranks up perfect sets idles perfect give it gas does great it revs up great wheni take off in first it’s good but when I hit 2nd ,3rd etc to open her up it wants to go but then it will like bog down on me and won’t accelerate to wide open I’ve also got the needles both on 4 notches what do you think I should do… I was thinking maybe going down another notch on both needles to hopefully it will give me more gas when I try to open it up what yu think

i got a question it starts up fine but when i give it gas it bogs

How can you adjust the throttle body I seen most of your videos but have not seen any set.

Thanks for breaking that down man, Cheers.

How do you get the niddle guide out?

Bro thank you I just bought one and your the first video that got it running I was about to sit it on fire

I have a 2002 raptor 660r that I just got guy said that it would be hard to start and would die and I got it and it will turn over great but will not start I’ve tried stater fluid but still doesn’t start

Hi is there any way of getting in contact with you. I have a few questions for you regarding this please.

Man I have come back to your video like six times thank you so much

I have shine questions for u

Hi I have a 2001 660R raptor stock. fuel mixture for both are two turns out and the other one is three turns out?

Where can I get that back bumper??

My quad when gets warm d up has a low rpm sputter when I first get on it but then comes out of it. At higher rpm. .I have pipe stage 2 dyno jet k n. Pro Flo kit modded box.

What yr model is this is on, I have a 2000 Silverado 5.3 that I just had a new Powertrain engine installed in. It’s burning thru ridiculous amounts of oil and warranty Dept said it could be bc of the drivers side valve cover not being updated. Just not sure it would be burning a qt of oil per tank of fuel bc of the valve cover. Any input would be appreciated.

Hello I have a raptor that I'm having problems

Can you answer a question I have?

I have an 02 660 new carbs aftermarket it runs fine starts right up you can give it full throttle wants give it full throttle again and it’ll stall out but if you stay in the throttle it will stay running wide-open what’s my problem new jets

Hey man are you still active on here

Why pull out the whole carburetor

You still doing work on four-wheelers?

Hey bro your video is amazing. The quad launches perfect but when I get passed half throttle it lacks power and kinda sputters what do you suggest I do next ??

Great help