Відео

Yes... it okay to charge in liquid into the high side but the if the high side pressure is higher than the refrigerant cylinder pressure, the recharging won't be possible as the high side pressure would tend to push the ingoing refrigerant back. It better to charge from the high side if the compressor isn't running. Then, the high side pressure would be lower. Thanks

Many thanks. Would you like to watch my other video on how to identify wires meant for capacitor in a motor? Its a great video and such information is really rare.

@@JeremiahThomas-qr4on Gladly.Thank you!

Please repeat the question sir

My question is that can we give full load or what bcz I tried this but my motor heat up and if load is given means my motor stops by force of hand

It depends on your motor capacity and the capacitor used. The motor rating goes with capacitor sizing as well.

You should give 1/3 of the rated motor load

Load given should depend on motor rating please. If too much load is given to a motor of lower rating, it will definitely overload the motor

Yes please. Neutral and life(phase)

Motor is there phase motor but we are running it with single phase power(life n neutral).

Pls use 7.5uf capacitor. Sorry for the belated reply. I was away for a while.

One third of the power would be derived

Though it would run more efficiently.

415v(3phase). I am using 220v(single phase) to run it instead.

415v sir. Sorry for my belated reply pls. I was away for sometime.

Greetings sir. Please use 10uf for a hp. 20uf for 2hp, ect.

Depends on the motor kw/hp sir

Use 10uf per hp motor. 20uf for 2hp ect

Many thanks to you as well.

For example u, terminal of the motor connected with blue wire of the capacitor and short the red,

Greetings sir. I used w2 and v1 for the the power lines. U2 and w2 for the capacitor.

You may chose to use any of the terminals after changing the motor to Delta configuration. All you. have to do is the fix the two power lines on any of the 3 terminals(u2 v2 w2) then fix one wire from the capacitor on the last/empty terminal, take the remaining capacitor wire to any of the power cables.

Can you chat me up on WhatsApp so that I understand what you mean perfectly. +234-9065697879

A simple connection diagram would have been more easy to understand.

Greetings to you. Please use 10uf for a hp. 20uf for 2hp, ect. You could run motor of any size depending if your power source can feed the current drag comfortably. Your power cable also matter, pls use cables that matches the motor's current requirement. Thanks 👍

Thanks brother..