Відео

Looks like you don't have a thermostat, that doesn't work on all bikes unless the thermo opens to full open which is usually 2 fan cycles????😮

Chudák mašinka nedostává co by zasloužila 🤔😢😢

Where did you get that windshield from and how much.

thanks so much here i go thinking i needed to get a shop to do it im bout to order some right now

It's funny how he hit his gas tank with the screw driver right off the bat.

Isn’t there a little spring that goes inside there on the cable ?

could you send the link to the listing?

Dónde puedo conseguir parabrisas como ése

Hay senin çekeceğin videoya sokayım.

Thank you for the wiring guide. They work great, for about 45 minutes!! A couple of the led’s started flickering, 45 minutes later half are out. Hope they honor this $200 crap!

sooo my dumbass pulled that metal tip out of the clutch rubber trying to put this on, how do i get this piece back into the rubber

The engine is in the way

Hey having trouble getting at the screw for the intake do I just need a really long screw driver?

Don't care when this was made. Glad this is up here. Thanks

Ive been looking on how to put this cable back on after my engine swap. Youve helped so much dude. Godspeed🫡

i would love to see a step by step. Im swapping out the frame this month

What resistor are you using

I just got an M109r without front tuen signals. There are rear turn signals and they work. Where would the front turn signal wiring be?

I'm glad you were man enough to admit that you never done a clutch cable and then teach me how it's done. You being fast learner helped me fix my clutch cable. There is to many videos of morons acting like they know what there doing. I think you can honestly have good channel just doing shit yourself. Thank you for your guidance..your a mechanic and teacher and a non fiction production artist. Keep up with the good work. May the force stay strong in you.

This guy said 36" (inches) 😳 it's mm btw 😋

Ke video deierda

Hey sir… how did you ever figure out to get your headlight back on. I took mine off, and for the life of me can’t get it back on. I notice it took you a little while to get yours back in place. I tried all afternoon yesterday and finally gave up.

I know Suzuki sportbikes have a little nipple under the gas tank that you open up and shoots air out of it, some other motorcycles i believe you turn the engine on and shake it

The Amazon

Thank you I just had the same problem on my CB650R

Good video just changed my MT-10 to Evans waterless coolant and it got hot twice(light came on) @ idle. Rode it around the neighborhood & it stopped. But a few days later rode to work & noticed it would creep up to 225F then come back down real quick. I got home waited for it to get cold removed the cap idled it with a fan up front then it started burping a ton of bubbles around 225F & level went down noticeably topped it back off & it quit doing the big changes in temps. The bubbles create heat pockets.

does it work to raise and lower gears?

does it work to raise and lower gears?

รถในฝันผมเลย

Where did you buy the frame from

I know this is an old vid bit i was using it to see something with my cable route. Aside from that noticed the clutch return spring was missing. This is a vital part. Hope you fixed it.

engine ice is bad for your bike, it boils over at a higher temp, nuking your engine, regular antifreeze has a lower boiling point, telling you your bike is getting hot....that company should be sued!!!!!

Just bought a ninja 650r and was running it around the block for about an hour. Got back and shut the bike off and noticed a bubbling sound coming from the reservoir. It was definitely gurgling/bubbling from the reservoir because it was vibrating. I had the idle speed on a bit too high, but I assume this is probably the issue. Dont know what coolant the guy used so ill be changing it with engine ice. After turning the idle speed down i rode around on it again for like 10 minutes and it didnt make the gurgling sound but im still gonna change it and shake those air bubbles out like you did. I really hope this is the problem and not something else

All that talking is not necessary.. Jesus Christ

قال الله تعالى(وَالَّذِي قَدَّرَ فَهَدَىٰ) . الايه قَدَّرَ قَدَّرَ قَدَّرَ .

Track edition

Cuánto vale esa bellosura

How did you get out the one that was stuck?

Lmfao

Bruh wtf is this

Nice

Wow so bferi foll

How are you going to prove purchase of the motor if it's the same serial number as the frame as they should match they will ask you this when you register it

Is the bike running or off?.

Thanks

look forward to watchin your journey brother - from Australia

Where did you get those levers from cause I have hydraulic clutch also but can’t fine none

Where did you get your clutch cable from? You're in t.o right?

Great video, thank you very much.

Thanks man, just removed it on my k3 and now i cant seem to figure the stupid bracket on top of the oil cooler...ill give it a shot in the morning. Mine only has 2 bolts unlike yours with 3, and i cant understand if it should go behind or in front of the oil cooler