- 21
- 654 362
South-East Automotive
Приєднався 2 січ 2014
A-Pillar Trim Repair - 2015 Vauxhall Corsa
Repair of a loose a-pillar trim on a 2015 Vauxhall Corsa E.
Replacement Clip: 39015275
Replacement Clip: 39015275
Переглядів: 377
Відео
Tail Light Bulb Replacement 2015 Vauxhall Corsa E
Переглядів 1,2 тис.6 місяців тому
Replacement of tail light bulbs on a 2015 Vauxhall Corsa E. 00:00 Intro 00:19 Side Light/Brake Light/Indicator 01:30 Reverse Light/Fog Light 02:35 Outro
2015 Corsa E Fan Speed Fix
Переглядів 8697 місяців тому
If your Corsa E or D has issues with the blower motor only working on setting 4 it is likely you have a blown heater resistor. To get the blower motor working on fan speed 1, 2, 3 and 4 you will have to replace the blower motor resistor. This video shows the steps you need to take to replace this component.
Citroën DS3 Air Filter Replacement
Переглядів 3,2 тис.11 місяців тому
Replacement of the air filter on a 2015 Citroën DS3 as part of a service.
Citroën DS3 1.6HDi Fuel Filter Replacement
Переглядів 2,3 тис.11 місяців тому
Replacement of fuel filter element on a 2015 Citroën DS3 1.6HDi as part of a service.
Citroën DS3 Cabin Filter Replacement
Переглядів 1,9 тис.11 місяців тому
Replacement of cabin filter elements on a 2015 Citroën DS3 as part of a service.
Citroën DS3 Headlight Bulb Replacement
Переглядів 3,8 тис.Рік тому
Replacement of headlight bulbs on a 2015 Citroën DS3. 00:00 Into 00:55 Main Beam (H1) / Side Light (Clear Capless 501 12V 5W) 02:06 Dipped Beam (H7) 03:36 Indicator (Amber 581 PY21W) 04:04 Outro
7" Sealed Beam Headlight Upgrade - 1968 Triumph Spitfire
Переглядів 278Рік тому
Upgrade of a traditional sealed beam style headlight, these have a reflector to the rear and the beam pattern is created by the lens. The replacement "Crystal Clear" style uses a shaped reflector to create the beam pattern and has a smooth and clear outer lens. Combined with a H4 bulb, the new headlight not only gives better light output, it also allows you to source replacement bulbs easily wh...
Wiper Blade Replacement - 1968 Triumph Spitfire
Переглядів 157Рік тому
How to replace the wiper blade on a 1968 Triumph Spitfire
Wiper Arm Removal - 1968 Triumph Spitfire
Переглядів 435Рік тому
How to replace or reposition wiper arms on a 1968 Triumph Spitfire.
Rear Indicator Replacement - 1968 Triumph Spitfire
Переглядів 168Рік тому
Rear indicator replacement on 1968 Triumph Spitfire with Lucas L594 bulb holders.
Fuel Filter Replacement - 1996 SAAB 9000
Переглядів 2,1 тис.3 роки тому
After replacing the fuel pump on this vehicle a new filter was fitted.
Walbro GSS341 Fuel Pump Upgrade - 1996 SAAB 9000
Переглядів 1,6 тис.3 роки тому
This SAAB has almost reached 200,000 miles, as a preventative measure a new fuel pump was fitted. The Walbro GSS341 is an upgrade over the standard unit, however requires a few modifications to be done to the fuel pump assembly.
2011 SAAB 9-3 Door Lock Replacement
Переглядів 17 тис.4 роки тому
The drivers side door lock on this 2011 SAAB 9-3 had an intermittent fault which meant occasionally it wouldn't open. A replacement unit was fitted which has cured the issue.
SAAB 9000 Reluctor Ring Replacement
Переглядів 1,4 тис.4 роки тому
An intermittent fault was noticed with the ABS system on this SAAB 9000. The warning light would intermittently illuminate and when braking at low speed the ABS would activate. Upon inspection it was noticed that the reluctor ring on the CV joint was damaged, giving a false signal to the cars ABS system. A replacement reluctor ring was fitted, curing the issue with the ABS. ABS Reluctor Ring - ...
Door Mirror Replacement - 2010 Fiat Panda
Переглядів 75 тис.6 років тому
Door Mirror Replacement - 2010 Fiat Panda
Rear Brake Caliper Rebuild - SAAB 9000/C900 With Rear Handbrake
Переглядів 6 тис.6 років тому
Rear Brake Caliper Rebuild - SAAB 9000/C900 With Rear Handbrake
MKII Skoda Fabia Door Trim & Microswitch Removal
Переглядів 82 тис.8 років тому
MKII Skoda Fabia Door Trim & Microswitch Removal
Which light's model we need for ds3
Did you manage to remove the lock without removing the windows? I've tried sliding the lock on my 9-3x (2009) past the window slide bar but it's too small a gap.
Thanks for the great video - helped me replace the drivers side passenger door actuator on my 9-3 this afternoon. Cheers!
Thanks!!!
Professional job
Grazie🎉
You forgot to put the filter cover back up. 😊
I just changed the rear right indicator bulb but the dash warning still comes on and new bulb don't work. Any idea what else it could be?
I heard it needs to be teaching to the car to work. Is it true?
Not a headlight replacement
How much of an upgrade over stock is this pump? Is your 9000 2.3 T?
Thank you. Very useful!
Sometimes you dont need commentary for a video to explain the job process. Well done
1:42 most important part, are covered by wire xD
Brilliant advice, yup, only took about 10 mins. Thank you Sooooo much!
You're very welcome, glad the video helped!
Thanks for uploading this video, going to prove very helpful when I change it in my wife's car tomorrow.
Thank you
Вчера этим занимался....
Really nice. Just did this operation myself today, but it still won't start though there is pressure in the lines (complete with air bubbles...). Either bad fuel, too much air in the fuel lines, or no spark. Need to check tomorrow on daylight, first with starter gas to see if it hits, then if that fails replace the spark plugs and ignition cassette. I'm really hope it's not injector failure, but they can't ALL fail at once I think.
Did you figure out the issue? I also changed my fuel pump and it just kept dying, so I'll need to revisit my old Saab.. which lives in the garage.
@@lukemallory7832 Yes, it was the injectors that were locked up. Apart from that you need to make sure that the ring around the pump forms a seal so that you won't have any nasty surprises. If you get fuel to the injector rail, enough to spew decently in a bottle then it's not the fuel pump that's being an issue.
@@Adrian2140 Thanks very much. After fitting the new (cheap) pump my symptoms are that the car starts and idles but stalls eventually. E.g. if I leave it running for say 10 or 15 minutes, it eventually just coughs and dies. If I try to rev it, it stalls sooner - and none of the time does it make the power it did before. I haven't looked at the car since last summer but with the weather improving, time to have another go..!
@@lukemallory7832Yeah I have those symptoms too car runs but it's either not getting enough air or spark (I tested spark but not the ignition cassette). I suspect it's the idle control valve that's stuck off though Car hadn't been moved in over 10 years and ALL the injectors were stuck, never seen that before. I took another idle control valve from a wreck and cleaned it up / oiled up as well as the old injectors, but I haven't put them in since I don't have a garage and it sucks outside.
Show 👏👏 👏
Where can a correct micro switch be sourced?
The part numbers for the door microswitches are below: Left Door Lock - 3BD998785 Right Door Lock - 3BD998786 If you search these part numbers online they can be purchased from a number distributors.
Thanks, you saved my day today :)
Thank you very much, in my country the steering wheel is in the left side but the center display is the same, i was thinking that the lights are leds (much dificult to fix) like the instrument panel, but is not like that. Greetings from Santa Rosa-La Pampa-Argentina.
is that why door says it's open when it's shut
Still have trouble that little yellow clip! Any tricks, cant see the 2nd screwdriver. Thanks!!! Don
Thanks! My lock wouldn't open from inside our outside. Wasn't sure how to get the panel off, but when I started working on it, my wife just came out to tell me something and the door opened. All the cables look great so now the lock assy will get replaced. Must be part of theft. Amazing, inside of the door looks like new. Love this car.
Great instructional video. Do you need to disconnect the negative on the battery first?
Bravo hai fatto un buon lavoro 👍
There is anyway to replace those horrible red buttons? it's the first thing you see when you enter the car ... and they are horribly.
Salut à tous. Je me doute que cette vidéo ne date pas de la semaine dernière mais j’essaie. Enfaite j’ai fais l’échange de mon afficheur odb de 206 1.4xt 2005 1 ligne es j’ai trouvé un odb 3 ligne. Il fonctionne mais lumineusité très faible après j’ai fouiné sur caradisiak es sa devrait passé selon eux. Je suis pas sûr pour la conso essence mais ouverture de porte avant et arrières sa me fait le dessin donc nickel juste éclairage super faible peut-être ampoule pas assez puissante? J’ai mis celle de l’ancien es pas mieux
Vert clean and easy, Thanks ! 👍
pug 206...286 capless bulbs.12v 1.2 watt.you will need 3.
thanks 🥰
Great video , Thank you for sharing this , I just fixed my son’s car yayyy . 👍👌 Liked and Subbed
Thank you... My display is still working, when I shine a light on it but there's no light. Now I know how to change it.
Thank you ☺️
Thank you for saving a broke student god knows how much!
Nice
Fantastic. Very good and informative guide.
super attentivo !mille grazie !
great vid thanks its still helping people like me 🤩🤩 if only you mentioned the ref number for the bulb or bulb info
Good to hear the video is still helping people out! Link for the bulbs is in the description.
Well done... informative... helpful... and if you were nearer I'd let you do mine!!!
Hi, i have this kind of lock in my Fabia 2 (2010) www.skoda-diely.sk/nahradny-diel/5n1837015m-zamok-dveri-lavy-cn-28627.html and i can´t change the microswitch, can you help me ? Thanks.
Great wee video with no in between jargon !
I had this issue and replaced the lock. Problem solved.
omg thank you so much!!!
It's actually door latch not lock,IMHO lock is with key hole.
If it helps the screws will most likely be the original small Torx head T20 types, not crosshead or Phillips unless lost and replaced. Wiring socket on clock unit has a clip which swings over the top of the plug when inserted to lock it into place. You can see it square on at 0:38. Imagine pulling that flat flange around the top towards you and off the end of the plug so it lies flat on the socket edge.
what do you do about the handbrake circlip cover disk that was damaged on disassembly?
The repair kits linked in the description come with a new cover. You can install this by tapping it with a mallet and socket. tinyurl.com/y58tlq78
Thanks for this, but I just snipped wires on switch and soldered new one on, didn't take it apart, worked👌👍