- 100
- 180 532
Juan “John” Bernal
United States
Приєднався 12 вер 2013
Move forward with faith and confidence because done is better than perfect!
Old timer with courthouse blues.
The old timer was jamming on the harmonica while the sheriff's officer was using his metal tumbler cup as a makeshift drum set.
Переглядів: 4 506
Відео
Detailed how to replace the radiator on a 1998 Cadillac DeVille with a 4.6 L Northstar V8.
Переглядів 2,3 тис.7 місяців тому
This is a detailed how to replace the radiator on a 1998 Cadillac DeVille with a 4.6 L Northstar V8. Watch until the end for video suggestions on how to replace: -Serpentine belt and idler pulley. -Thermostat -Tips on putting the the radiator back on. This video applies to the seventh generation Cadillac DeVille 1994 1995 1996 1997 1998 1999 with 4.6 L Northstar V8 engine.
Detailed, how to replace the idler pulley and serpentine belt on a 1998 Cadillac DeVille.
Переглядів 1,5 тис.7 місяців тому
This is a detailed and step by step video. Includes a diagram of the routing of the serpentine belt and explanation of each loop/ location of: -Power Steering Pump -Alternator -Idler pulley -A/C compressor -Crank shaft / harmonic balancer - Belt tensioner This video is how to replace the idler pulley and serpentine belt on a 1998 Cadillac DeVille with a Northstar V-8. Here is a link to the serp...
Detaching A Trailer on a hill / slope / slant / incline.
Переглядів 5258 місяців тому
How I detach a trailer on an hill / slope / slant / incline. Rental trailers are great because they are like secretly owning a truck and without the instant weekend best friends asking you to help them move a couch, fridge, stove, etc. Trailers are great but they are also dangerous be safe!
Wrapping of the Cable.
Переглядів 318 місяців тому
We have an ethernet cable running through the house. The cable was fraying so we did a splint with zip ties and a patch with electrical tape.
Testing for Combustion Gases in Coolant.
Переглядів 2508 місяців тому
After the Caddy cracked a radiator and overheated I did a test to see if there were combustion gases in the coolant. If the test were positive that would indicate a cracked head gasket and more money! It is such a huge blessing that the test came back negative! This is a test for combustion gases in coolant on a 7th generation, 1998, Cadillac DeVille with a Northstar. This procedure is the same...
1998 Cadillac Deville Radiator Pressure Test.
Переглядів 1228 місяців тому
This is a pressure test on a 1998 Cadillac Deville I used the Harbor Freight part # 63862. Note that the kit that I purchased did not have the adapter for specific for this style of radiator cap. I had to carefully use another adaptor to run the pressure test after careful centering it worked just fine. This video applies to the seventh generation Cadillac DeVille 1994 1995 1996 1997 1998 1999
Erika Bernal Nauvoo 2024 Pageant Audition.
Переглядів 213Рік тому
Erika Bernal Nauvoo 2024 Pageant Audition.
Experimental Hovercraft Intro for Power Racing Series.
Переглядів 812 роки тому
Experimental Hovercraft Intro for Power Racing Series.
How to thread, bobbin, and use Singer 2517C sewing machine.
Переглядів 14 тис.2 роки тому
How to thread, bobbin, and use Singer 2517C sewing machine.
Weekend at the Peach State Air Strip 3/13.
Переглядів 913 роки тому
Weekend at the Peach State Air Strip 3/13.
How to change the fuse for the A/C clutch on a 2008 Chevy Malibu.
Переглядів 1,5 тис.3 роки тому
How to change the fuse for the A/C clutch on a 2008 Chevy Malibu.
In behalf of fatherless children everywhere, I thank you (poppa)!
It helped me a lot. I didn't know how to do it. Thank you for the video.
love it!!!!
Hey so I got a 1998 caddy deville I just had my hoses replaced cuz it was overheating but now it says coolant hot idle engine so my question is why it's overheating again is it my thermostat
I agree...too difficult
C harp?
Awesome.
How much would you charge to do this on the same car?
I wish people would video the WHOLE TIME. I can't get the new friggin plug into the harness to save my life. No idea how. 3 people have tried. Help? Lmao
Did you have to support the engine from below with a jack before removing the engine mounts?
On my DTS, I couldn't get it in with the inner piece snugged down. After loosening it, the pulley went in easy. Everything tightened up nicely. Amazing how the basics of this engine stayed the same for so long.
can i upgrade to 16 ram? or can it only be 8?
awesome playing...loved it lmao
Loved it
Trumpie dumbie blues
Quite obvious they never done this before
Thank God you showed a detailed explanation.... show me how to take out the alternator out while the radiator out
that was nice!
fantastic!!! loved it
Improvise, adapt, overcome.
That was great 👍🏻
Cut!😂
Brick 👍
That a Northstar with a blown head gasket the headbolt pull out the threads. Does it run hot driving but not sitting still
My favorite chevy truck is a ford.
Damn, old son, sing that sumbitch!!!
Cinderblocks not bricks
Break once and both y’all backs broke 😂😂
A ton of "bricks"👀😂
Wtf?
That’s not a… dang
How messed up was the back seat afterwards
The back seat was just fine. I drove slowly home.
Music mixed too loud, dog
Great video. My coolant levels drop but there is not one leak and radiator is new. The check engine light came on and the code P0420 read catalitic issue bank 1. I will try this first to make the coolant isn't combusting.
I keep losing coolant also. When I run the codes on it I get a surge tank error code. I've checked the "burp" tube and the "hollow bolt" and they are no clogged next I will use a syringe to "flush" the burp tube.
Check out this video I did on cleaning out the burp tube using a catheter syringe. It may help with your issue. ua-cam.com/users/shortsFeaofoSTbto?si=N-WjSnxbzUlUgSlD
Very helpful. Thank you!!
thanks Brother. Great video, very detailed. Im going to replace my idle pulley tomorrow!
Make sure that you get the correct idle pulley measure. The first time the Auto Parts store sold me the idler pulley that goes on the tensioner.
“I don’t know why the hallway beeps”
Turn off the distracting music to make this a more professionally done video!!!!
'PromoSM' 🤣
Thank you!
thank you
By pass the ballast with LED
Nice and to the point, thanks
Great job! Good luck!
Ermmmm slay 💅
Gorgeous young lady. She's going to do amazing.
Thank you!
Glad to.
You can’t just change the bulb? You have to buy the whole thing?
nice job , my van is an e350 2008. does not match......enough. 2 best thing about video, you were helping your son or some kid: and you mentioned your companion. I had several companions during my two year service. Still faithfull and true.
I just purchased the Kodak orbit 360 to realize that Kodak does not have the software to edit the files for desktop Mac. Do you have a tip to which alternative I can use to view and edit the movies?
You can use what ever program you want to edit the video. I use Filmora. The trick is to get the video stitched together as as 360 video. After editing the video; to stitch it in to a 360 video I use "Spatial Media Metadata Injector" I don't remember where I downloaded it but that does the trick.
Hi! You Know y is the number for this bobbin?
It is standard size bobbin that came with the machine.