Відео

The fact that half the stores r closed now is so sad

It's a little over kill using the sheet on a concrete floor yes if it was a timber floor !👍

Loots nice what's the cost per mtr or rolls ???

Very informative but BAL please next time you do something like this invest in a decent microphone.

Appreciate the detailed breakdown! Could you help me with something unrelated: My OKX wallet holds some USDT, and I have the seed phrase. (air carpet target dish off jeans toilet sweet piano spoil fruit essay). How should I go about transferring them to Binance?

How deep does it need to be to stay into place

I have laid a lot of patios before using sandstone and concrete, but I will soon be doing my first porceline patio. I like this product, but I wanted to ask, do you still have to use a SBR slurry on the back of the flags when using a tile adhesive?

Can i use 1/4 inch cement board on a masonry tub/shower wall since it's solid?

Can I use the same adhesive for under membrane which is my concrete subfloor and use same adhesive over membrane for sticking tiles?

What's the blue stuff on the roller

Why can you not pay on compacted type 1 and sand with porcelain?

At last 😂😂

At 0:24 it says "mark 50mm up", so why does the video show him marking 150mm up...?! What is the correct height, 50mm or 150mm??

'promosm'

is this available in the USA

Which glue dries slow for wet rooms

Does this go into plasterboard?

Can I get a translator, please? 😆

Do you have to tile 3 hours later? Or can you come back and tile any time?

You idiot mo need to prime , and for what the gap tape 😂😂😂😂 if you Gina tile on top

Bal best stuff on the market 💪🏻

Fantastic music choice.

The tiles were already grouted actually.

Ive used this the other day good stuff & drys out quickly to a super hard finish with some unusual colours in its range, So yeh good stuff.

Dude you should off left the handel on that brush that way you wont be on your knees, think smarter not harder 🤔👍☘️🇮🇪

12 hours later - Is that just water you use to clean it?

why you grouting the tiles and the grout lines?!

Promo SM

What thickness of type 1 needs to go down first ?

We do 150mm compacted type 1, then 40/50mm sharp sand and cement 4:1 bed with 6mm mesh in the whole area. Has load strength then and also tensile strength. Anything fairly big without steel will end up cracking and tiles will move.

Hi what colour was the bal terrace grout in this video thanks

Can I do this process over a stained concrete patio? Greetings from Los Angeles

What mixes do I do for tile on tile? And how long to leave between coats?

I think using mix of cement and sand for leveling layer and do leveling together with tile installation might be easier

I could be wrong, but this looks like a load of bollox

Plaster wall will it work

how many square meters can we cover wıth one bucket?

The screw went straight through the backer board at 1:47 - better use a slower speed on your driver :D

No explanation as to how to pre-fix the wall plug . . . .

Didn't really go into the mechanical fixing process properly I mean using one drywall screw into block what was that all about you need to do the video again but do it properly for my and everyone else's benefit please! Emmmm you lost me on the drywall screw ahahah

Hi, Just purchased BAL WP1, want to see how to use it😊

So I'm laying some 20mm thick porcelain tiles onto an external concrete slab and tile wholesalers recommended this stuff...the slab 4mtr X 5mtr has some run off(fall) to drains etc. Now I did the slab and it's pretty level but not perfect I'm sure..my dilemma with this stuff is it looks like you have to rely on the sub floor being perfectly level. As in...if your doing the more traditional back buttering of the tiles if gives you a little more scope to setting your levels more accurately...using let's say a 20mm notched trowel you could vary you level by up to 10mm by the amount of pressure/vibration you apply to the tile as you bedding it down...with this stuff it appears, mainly because your not back buttering, that this option is not there..? Appreciate any thoughts as I'm kinda leaning towards a more traditional back buttering approach.

Useful video thanks. Would the BAL FLEX be suitable to use with my ceramic tiles in the hall? 2mm gap and 250mm tile size.

These videos are a load of crap . Why do you show a glass tile being pushed down to show a solid bed show everyone how you fit the next 20 glass tiles around it and push them down the same for solid cover , lets see if theres any lipped tiles.

Definitely one of the more complex one on the tube… too many steps and don’t even want to think of the material cost

𝔭𝔯𝔬𝔪𝔬𝔰𝔪

Word of the day....ACTUALLY

Do you prime the masonry wall prior to putting the tile adhesive on?

This is not a case study. After the location description it is the same video as the original advert!

I've been looking for a way to add some curb appeal to my front yard and back patio so this is perfect. Thank you so much for sharing!