Відео

Wow great idea 💡

Why don't you push the tube and stop making a mess !

СЪЖАЛЯВАМ,НО ТАКА,И-РАЛНИК НЕСЕ-ТОЧИ.👀🫣👁️👁️🫣

👍👍👍

good

Novel idea. Predrill edge cuts, no splitting. Countersink them if you want to be fancy, soap, ive seen that before. Absolutely useless. As far as the others, i have used wood shims where i Absolutely have to, or i move up a size of screw, sometimes not an issue, the baking soda and ca glue stripped out immediately, even with a lower power drill than im used to. Might hold with a full threaded screw rather than one with a shoulder, but the ca (cyanoacroylate glue) will only penetrate about 1/4-3/8" so the shoulder will just spin in the loose powder underneath. The wood shims with a bit of wood glue, leave it set for a bit then drive the screw is the best option if you can't use a larger fastener, other option is to double check the hole size you need to drill, and go from there. Everyone makes mistakes though. I have many times. A lot of these "quick fixes" will they work? Technically. Other than the ca glue and sodium bicarb for that particular use. Great fo glueing plastics however, dust it inbetween the pieces, put ca down, add a smidge more bicarb down, and a drop or two of ca. Works a treat.

new ideas are sloppy

Very good

Классно

Wow 👌 👏

Great ideas 💡 👌 👍 👏

You should have also used a diamond hone it will remove the burrs can leave a cleaner and sharper edge for a more cleaner cut.

interesting and some are inventive. But most ave been on You Tube before; have been using some of them for a few years. But don't stop looking for ways to make work hacks better.

I will definitely try it 👍

great idea

Красной изоленты нет, а с синей не работает.

I wish you luck 🙏

💡💡💡

Thanks for this great helpful tip

Very good 👍

Guud

Vaaauuuuvvv gap yo'o' 👍👍👍

😳😳😳😳👍👍👍👍👍

👍👍👍👍👍👍🙌🙌🙌

Not bad bro!

Wow 👌 👏

желаю удачи в будущих начинаниях

we are glad to see you

I wish you luck, master

I wish you luck in your future endeavors

It was a very necessary and useful farewell

How about undercutting the trim element? Like you are supposed to...

WOW... And they say we didn't go to the moon get down brother...

Wooow

You don't need to mark the disc in the first method.

Is that a thumb or a toe?

I'm certain all 3 methods work, but probably not as neat as the first one considering the same piece was shown for all 3 results, LOL.

The level of accuracy marking with a chubby fat marker? And why not use a pair of compasses rather than groping round your tool bag for something which MIGHT fit? 😂

Should probably use a multi tool to cut the bottom off instead to allow expansion

👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍

very useful video

I wish you luck bro

Very good luck

Perfect

Perfect

Food

Bravo

Bravo 👍👍👍👍

Bravo

Great