Відео

Appreciate the video!

How do u get your new power brake booster

Great job. Thx

Bad video. Should've showed the process

Bro. excellent video, thank you very much.

Hello! I am doing this on my 2019 Nissan Kicks. Do you happen to have the torque specs for each part for when you put it back on?

I have the exact same issue. Replaces the chain, guides, solenoids and checked the wiring to the PCM. P0011 I have to take it apart again to do the sprockets.

Some remove the manifold for more space

No way you took the drivers side off so quick, the damn lines running into it are in the way it wont budge

Are you in Florida?

where are you located? I need mine replaced and thought about doing it myself but it looks like a lot of work. I don't have the room at my house to do repairs and our pinche HOA doesn't allow us to work on vehicles at our house.

If replacing... The transmission lines are oil or coolant?? Do i need to do extra steps?? Top off anything else relating to transmission?

ugh. im dreading doing this job on my dead Z4

I’m looking to replace mines on the front, but I don’t know which brand to get. Or where I could order the parts already assembled and pressed. Help!

After you move clamp for the brake pedal what the next step

Also I bout a radiator from autozone do you think it will have the seating point for the condenser as well?

How many quarts of coolant was used to refill the radiator

One step was missed for this to come off, wall the window is down there is a screw behind the rubber plugged hole in the middle lower part of the panel that holds the plastic to the glass

I keep hearing a loud humming noise when I drive my 2020 Kicks SV especially when I drive 40 to 60 mph and then a swirling noise when I turn left or right. Is it my wheel bearings?

There’s no way you got that last bolt with a wrench the first one yes but the last one no way you need a small ratchet or a big ratchet with a long extension with swivel. The last bolt is the hardest to get in my opinion over everything

Hey bro, I just replaced my front wheel bearing thanks to this video. Tools and parts cost around 500 total. Much cheaper than the dealership and I now know how to do this. Excellent video.

‘Room is tight’ is a major understatement LOL Some say to pull down the cats etc. extremely difficult when no lift…

I replaced the front wheel bearing on the same car but now the light on the front panel is on and engine light too thank you

How do you reser de speed sensor light after changing the wheel bearing

How did u get the second bolt out? On the other side

I appreciate the video brother. I like to make sure im not screwing up before I finish taking it apart and this was the only video I could find.

Hey man! Thanks for the video.. so my radiator just blew yesterday 😢 I wonder what was the reason it did that?

Clear & straight to the point…. 🔥🔥🔥

You got instagram I have a question

Was getting P0010 & P0011 code changed them out on my 2013 2.4 Equinox 150k miles , and still getting P0011 code along with stalling and shutting off. Thinking the procedure you have done in this video is gonna be my next step . Thank you sir

I was expecting a more complete video from removing the inside door handle, etc. Did you fix the window wire thing or was the regulator bad and you replaced it? . In my Kia Soul the rear window goes down but doesn't come back up, unless the button is pulled up from the driver's door button. I don't know how to remove the door things and this video helps but I now I need to go hunting for more videos. Thanks for the content anyway

How do you get the door panel off? I removed the screws but I can't get it to come off