Відео

sir we have 2 streams one is liquid propylene stream and other is gas propylene stream. on liquid we have 16 nozzles which is going to top of the reactor to control the temp. and found bottom we have 11 nozzles for gas propylene. we have to maintain V /L ratio. controlled flow is liquid & wild flow is gas stream. our polymerization reactor is a horizontal reactor with agitator. reactor have 5 zones. if one of the zone temp increase, liquid flow will increase for that particular zone to bring down the temp inthat case how ratio control will works. Also in gas stream we are injecting Hydrogen to maintain MFR of the polypropylene. can u explain this properly? .also tell me what is mean by bias V/L ratio?

👍

thank you sir

Thankyou sir ji

Best explanation ever Thank you so much!!

Hola podrias ayudarme de donde sacas la informacion

Many Thanks for useful tutorial.

Please is there any recommended book for our consumption

6pin dtc ic ka number kya hai aur ic kaise dikati hai

Thanks sir......it was really helpful 🎉🎉🎉❤

What should be the value of resistor and capacitor?

Sir Vh should be 25 naa ?

Sir can you please provide notes for suppressing the influence of external disturbances

JAI JAI

Thank you so much. I am PhD student working on a MIMo topology i need to implement decoupled control system. For further queries in the same Can i ask for your contact number sir?

Stephenapaulas

Good day sir. Excellent explanation. Thanks for your honest efforts.

Why did you stop uploading sir?

can we also use feedback control scheme for the boiler water level scenario

Excellent

Very well explained!

Informative 🙌

Sir is there any video on PID concepts and delays involved in it. I am computer engineer and in one project got to work on PID system for autopilot of a boat. However, due to lack of proper handling of delays and noises it did not went through.

Thank You So Much Sir!

excellent explanation❤

thankyou sir

Excellent explanation.... everything was well presented Thankyou for the video

your videos are blessing !!! i scored good coz of you!!! much love

Nice explanation 😃❤️

Sir aapke karan hi kal ka paper paas hoga ab🎉

Ossmun big fan ❤

excellent explanation

How to deal with such problem when you have more than one steam coil in practice?

Amazing Explanation. Thank you

Thank you! DD

You repeat yourself too much sir! Let me go to LearnChemE.

I can understand what you are teaching, and I'm learning! Other UA-cam teachers in this subject will drive you nuts. Some of their accents are too sharp to understand their words!

what would the diffrence be between a tublar and a plate heat exchanger?

Good 👍

Mandeep Sir do you have any information about set point weight? Can you please explain what it is and when to use it?

nice explaination sir

Great video

Thankyou Sir

This has helped me a lott .......thank you

Can u provide notes please

Please give your email

Thanks 🙏 a lot Sir. This video was very helpful for me😊

Best Lecture Available on UA-cam

Why in the matlab you only use 1 output if it requires three (Kp, Ki, Kd)?

Tussi great ho sir